GaAs SP4T Absorptive Switch with ASIC Driver, DC - 3.0 GHz SW65-0314 V 6.00 Features n n n n n n n n SOW-24 Typical Isolation: 33 dB (2,000 MHz) Typical Insertion Loss: 1.6 dB (2,000 MHz) Integral ASIC TTL/CMOS Driver Plastic, 50 mil Pitch, SOW-24 Lead, Wide Body Low DC Power Consumption 50 Ohm Nominal Impedance Tape and Reel Packaging Available Test Boards Available Description M/A-COM's SW65-0314 is a GaAs MMIC absorptive SP4T switch with an integral silicon ASIC driver. This device is in a 24-lead plastic package. This switch offers excellent broadband performance and repeatability from DC to 3 GHz, while maintaining low DC power dissipation. The SW65-0314 is ideally suited for wireless infrastructure applications. Also available in a ceramic package with improved performance. Package outline conforms to JEDEC standard MS-013AD. Electrical Specifications: TA = 25°C Parameter Test Conditions Units Min Typical Max Insertion Loss DC - 1.0 GHz DC - 2.0 GHz DC - 3.0 GHz dB dB dB — — — 1.5 1.6 2.0 1.7 1.8 2.3 Isolation (All arms off) DC - 1.0 GHz DC - 2.0 GHz DC - 3.0 GHz dB dB dB 35 30 25 38 33 27 — — — DC - 1.0 GHz DC - 2.0 GHz DC - 3.0 GHz 10%/90%, 90%/10% 1 50% TTL to 90%/10% RF In-band (peak to peak) — — — nS nS mV — — — — — — 1 dB Compression .05 GHz .5 - 3.0 GHz dBm dBm Input IP3 Two tone inputs 0.05 GHz Up to +5 dBm 0.5 - 3.0 GHz VCC — VSWR Trise Tfall Ton Toff Transients On 1.3:1 1.5:1 1.7:1 Off 1.3:1 1.7:1 2.2:1 15 50 50 1.5:1 2.0:1 2.4:1 50 150 150 — — +20 +27 — — dBm dBm — — +35 +46 — — V +4.5 +5.0 +5.5 VEE — V -8.0 -5.0 -4.75 ICC VCC = +5.0V mA — 0.2 6 IEE VEE = -5.0V mA — -0.2 -1 Logic “0” Iin = 20 µA max V 0.0 — 0.8 Logic “1” Iin = 20 µA max V 2.0 — 5.0 1. Decoupling capacitors (.01 µF) are required on the power supply lines. GaAs SP4T Absorptive Switch with ASIC Driver, DC - 3.0 GHz SW65-0314 V 6.00 Absolute Maximum Ratings 2,3 Pin Configuration Parameter Absolute Maximum Max. Input Power 0.05 GHz 0.5 - 3.0 GHz +27 dBm +34 dBm Bias Voltages VEE VCC Control Voltage 4 -8.5V +5.5V -0.5V to VCC +0.5V Operating Temperature -40°C to +85°C Storage Temperature -65°C to +125°C 2. Operation of this device above any one of these parameters may cause permanent damage. 3. When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm. 4. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. Pin # Function Pin # Function 1 RFc 13 C1 2 GND 14 C3 3 RF4 15 GND 4 GND 16 GND 5 GND 17 GND 6 RF2 18 GND 7 GND 19 RF1 8 VEE 20 GND 9 GND 21 GND 10 VCC 22 RF3 11 C4 23 GND 12 C2 24 GND Truth Table TTL Control Input Ordering Information RF Common To: C1 C2 C3 C4 RF1 RF2 RF3 RF4 1 0 0 0 On Off Off Off 0 1 0 0 Off On Off Off 0 0 1 0 Off Off On Off 0 0 0 1 Off Off Off On Part Number Package SW65-0314 Bulk Packaging SW65-0314TR Tape and Reel (1K Reel) SW65-0314-TB Units Mounted on Test Board Typical Performance Curves Typical Insertion Loss Variation at Temperature - Jx-J0 +25°C -40°C +85°C 2.5 Loss (dB) 2.0 1.5 1.0 0.5 0.0 0 500 1000 1500 2000 2500 3000 Frequency (MHz) Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. 2