SPDT PIN Diode Driver DR65-0003 V 5.00 Features n n n n n n SO-8 Moderate Speed, CMOS Technology (25 nS) Complementary Outputs High Drive Current Capability (± 50 mA) Low Current Consumption Plastic SOIC Body for SMT Applications Tape and Reel Packaging Available Description M/A-COM's DR65-0003 is a SPDT driver used to interface between TTL logic signals and PIN diode based microwave switches. High-speed analog CMOS technology is used to achieve low power consumption at moderate speeds. Low output resistances allow it to develop high output current spikes to ensure fast switching speeds. The complementary output stages are structured so it can be used as an inverting or non-inverting driver for SPST switches, or as a single input, complementary driver for SPDT switches. The monolithic die is packaged in a SO-8, plastic surface mount package and is available in tape and reel packaging for high volume applications. The DR65-0003 is ideally suited for driving M/A-COM’s line of HMIC switches. Package outline conforms to JEDEC standard MS-012AA. SPDT PIN Diode Driver DR65-0003 V 5.00 Electrical Specifications, TA = +25°C, +Vcc = + Vdd = + 5.0V ± 5%, -Vee = - 5.0V ±5% Parameter Switching Speed Delay Rt/Ft 1 Test Conditions Units Min Typical Max Spike current into 10 ohm load 50 % TTL to 90% 10%-90%; 90%-10% nS nS — — 25 2 35 5 PRF 50% duty cycle MHz DC — 5 Output Voltage Drop, No Load With reference to supply voltage V — — .25 DC Output Current Peak Spike Output Current Load Dependant Spiking Capacitor in Circuit mA mA — — ±30 ±150 ±50 ±200 Output Stage on Resistance Positive Output FET, Qp Negative Output FET, Qn Ω Ω — — 15 20 20 25 Quiescent Supply Currents +5V -5V mA mA — — — — 1.0 .2 TTL Levels Logic “0” @ 20 µA sink current Logic “1” @ 20 µA source current V V 0 2.0 — — .8 5.0 Package Dissipation — mW — — 200 1. Decoupling capacitors (.01 µF) are required on power supply lines. Absolute Maximum Ratings 2 Pin Function Table Parameter Absolute Maximum Pin # Function Pin # Function +VCC 5.5V 1 N-I OUT 5 +Vee +Vdd must be = or < +Vcc +Vcc 2 GND 6 +Vdd +Vee -5.5V 3 +Vcc 7 GND 4 LOGIC 8 INV OUT TTL Input Voltage -0.5 V to Vcc +0.5V Operating Temperature -40ºC to +85ºC Storage Temperature -65ºC to +125ºC 2. Operation of this device above any one of these parameters may cause permanent damage. Truth Table Logic Input (Pin 4) “0” “1” N-I Out (Pin 1) INV Out (Pin 8) L H H L H: Iout is +Current L: Iout is -Current Ordering Information Part Number Package DR65-0003 Bulk Packaging DR65-0003TR Tape & Reel (1K Reel) Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. 2