PAW887B 40-860 MHz. 28 dB. CATV Ultra-linear Amplifier Features: (typical values) Ultra High Linearity Low Noise Figure Rugged Construction Operation over a wide voltage range Usable for 50 ohm operation Specifications @Tcase = 30°C (Referenced to 75 ohms) Typical Conditions Parame te r Frequency Range M in. Value M ax. Value 40 860 28 30 dB. 0 3.0 dB. +/- 1.5 dB. Units MHz. Power Gain* f=50 MHz. Cable Equivalent slope f=40 MHz. to 860 MHz. Gain Flatness (peak to valley) f=40 to 860 MHz. Input/O utput Return Loss f=40 to 300 MHz. 17 dB. Input/O utput Return Loss f=300 to 860 MHz. 12 dB. Composite Triple Beat (CTB) 110 channels flat Vo=40dBmV. measured @ channel 78 - 57 dB. Cross Modulation (XMO D) 110 channels flat Vo=40dBmV. measured @ channel 2 - 57 dB. Composite 2nd. O rder (CSO ) 110 channels flat Vo=40dBmV. measured @ channel 78 - 55 dB. IP3 / IP2 2 tone N oise Figure (N F) @ f= 750 MHz. 8.5 dB. @ Voltage of +24v. 340 dB. Total Current (I ) TO T 32/52 * Note: +/- 2.0 gain from 5 to 40 Mhz Outline Drawings dBm. Maximum Ratings Storage Temperature ....... -40°C to +100°C DC Voltage ................................. +28 volts RF Input voltage ......................... 40dBmV. Operating BaseTemperature .......... +100°C Pin Configuration Pin # Description 1 ...................................................... Input 2,3,7,8 ......................................... Ground 5 ........................................................ +V 4,6 ............................................. not used 9 ................................................... Output Specifications subject to change without notice Rev:040201 100 Emlen Way Telford, Pa. 18969 Tel. (215) 723-6011 Fax. (215) 723-6015