H HiTRON 66-160VDC INPUT RANGE DC-DC CONVERTER HOT-SWAP CompactPCI QUAD OUTPUT 250 WATTS RAILWAY SWITCHING POWER SUPPLIES HDC250P-110B-490(E) SERIES FEATURES: 250W 3U X 8HP EUROCARD PACKAGE 66-160VDC NOMINAL 110VDC INPUT DESIGN TO MEET EN50155 WIDE OPERATING TEMPERATURE RANGE OF -40°C TO +70 °C N+1 REDUNDANCY/HOT-SWAPPABLE ACTIVE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: Typ. 66-160Vdc, nominal input 110Vdc. Input Connector: Positronic 47-pin PCIH47M400A1. Inrush Current: Peak 10.5A at nominal 110Vdc. Input Current: 2.8A Max. at nominal input 110Vdc. Soft Star: Installed. Under-Voltage Protection (UVP): Installed. Input Reverse Voltage Protection: Installed. Dielectric Withstand: Meet IEC 60950-1 regulation. Input-Output: 1400Vdc, Input-GND:1400Vdc, Output/GND:500Vdc. EMI: Meet EN 55022 FCC Class A. Radiated Susceptibility: EN61000-4-3 Level X (20V/m). Surge: Meet EN6100-4-5 Level 3, L-L 2KV, L-G 2KV. Conducted Disturbance: EN61000-4-6 Level X (20V). Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: <Green> means valid input voltage. <Red> means a critical fault. Thermal Protection (OTP): Installed NTC for thermal sensor at [DEG#] pin. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 250W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: Typ. ±1% for V1/V2, ±2% for V3/V4. Noise & Ripple: Typ. 1% Peak.-Peak. OVP: Built-in at all outputs. Adjustability: Available at VO1, 2 & 3. Output Trim: Electrical trim available at VO1/2.[ADJ #] Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing device at all outputs for N+1 redundancy operation. Current Sharing: Active current sharing for all outputs. Power OK Signal: Available for all outputs. Over Current Protection (OCP): Installed in each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typical 120% max. load. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 79% at 110Vdc. Switching Frequency: 120K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 22mV and recovers within 0.1mS for 25% load-change. Vibration: Six degree-of-freedom random,10Hz-150Hz, 10G. Safety Standard: IEC 60950-1 Class I. Operating Temperature: -40 °C to +70 °C at full load with specified air flow Derates linearly to 60% at +75°C. Storage Temperature: -45°C to +85 °C. Cooling: At least 600LFM moving air is required to achieve full rating power 250W in a confined area. Power Density: 4.5 Watts/ Cubic Inch. Conformal Coating. NOTE: (1)All measurement are at nominal input, full load and +25°C unless otherwise specifications. (2)Due to requests in market and advances in technology, specifications subject to change without notification. (3)A warm-up time 10 minutes is required after cold start at temperature from -40 °C to +0°C. (4)Tantalum capacitors connected to system is suggested for bettering Ripple & Noise against operating temperature from -40°C to +0°C. Hitron Electronics Corporation. B4-11, P.O. Box 26-110 Kaohsiung Export Processing Zone Kaohsiung 806 Taiwan TEL: 886-7-8210410/FAX: 886-7-8419917, 886-7-8210511/E-mail: [email protected]/Web-site: www.hitron-e.com -1- Edited on May 22, 2014 OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @★#≡⊙ AUX. +VO2 ▲@★#≡⊙ AUX. +VO3 ▲@★#≡⊙ AUX. -VO4 ●⊙★ MODEL NO. Min. Typ. Volt. Max. Min HDC250P-110B-490(E) 0A 25A +5V 33A 0A Typ. Volt. Max. Min. Typ Volt. Max Pk. Min. Typ. Volt. Max. Pk. 18A +3.3V 33A 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A 0A Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "≡" 3rd wire Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post-regulator. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time. MECHANICAL DIMENSIONS: MM [INCHES] DERATING CHART WEIGHT: 611.0 g (21.6 Oz.) INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT ASSIGNMENT -Vin +Vin GND VO1 VO1 S+ PIN NO. 47 46 45 1,2,3,4 30 ASSIGNMENT VO2 C.S. VO3 VO3 S+ VO3 C.S. VO4 VO1 S- 34 DC COM VO1 Adj. VO1 C.S. 29 35 13,14,15, 16,17,18 33 32 EN# DEG# PIN NO. 41 20 36 44 21 5,6,7,8,9, 10,11,12, 19,22,24 27 38 INH# 39 FAL# 42 VO2 VO2 S+ VO2 Adj. Mating connector: PCIH47F400A1 Hitron Electronics Corporation. B4-11, P.O. Box 26-110 Kaohsiung Export Processing Zone Kaohsiung 806 Taiwan TEL: 886-7-8210410/FAX: 886-7-8419917, 886-7-8210511/E-mail: [email protected]/Web-site: www.hitron-e.com -2- Edited on May 22, 2014