H HiTRON 36-72VDC INPUT RANGE DC-DC CONVERTER HOT-SWAP CompactPCI QUAD OUTPUT 200 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES HDC201P-48B SERIES FEATURES: 200W 3U X 8HP EUROCARD PACKAGE 36-72VDC NOMINAL 48VDC INPUT INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS B CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 200W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: Typ. ±1.0-2.0%. Noise & Ripple: Typ. 1% peak to peak or 50mV, whichever is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1, 2&3. Output Trim: Electrical trim available at VO1/2.[ADJ #] Hot-Swap: Available. Remote Sensing: Available at VO1,VO2 & VO3. Power OK Signal: Available for all outputs. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs for N+1 redundancy. Current Sharing: Third-wire current sharing at VO1,2&3. Over Current Protection (OCP): Installed in each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typical 120% max. load. Consult the factory for special OLP setting. Input Voltage: Typ. 36-72Vdc, nominal input 48Vdc. Input Connector: Positronic 47-pin PCIH47M400A1. Inrush Current: Typ. 20A at nominal input 48Vdc. Input Current: 5.2A at nominal input 48Vdc. Dielectric Withstand: Meet IEC 60950-1 regulation. EMI: Meet CISPR EN 55022 & FCC Class B. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: <Green> means valid input voltage. <Amber> means a critical fault. Thermal Protection (OTP): Installed NTC for thermal sensor at [DEG#] pin. GENERAL SPECIFICATION Efficiency: Typ. 79 %. Switching Frequency: 110K Hz. Circuit Topology: Forward circuit. Transient Response: Typ. 3mS following 25% load-change. Safety Standard: IEC 60950-1 Class I. Construction: Eurocard 3U X 8HP X 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Operating Temperature: 0 to +50 °C at full load with specified air flow. Derates linearly to 50% at +70°C. Storage Temperature: -40 to +85 °C. Temperature Coefficient: Typ. ±0.02% / °C. Cooling: At least 20CFM(600LFM) moving air is required to achieve full rating power 200W in a confined area. Power Density: 3.7 Watts/ Cubic Inch. NOTE: (1)All measurement are at nominal input, full load and +25°C unless otherwise specifications. (2)Due to requests in market and advances in technology, specifications subject to change without notification. In application -97- OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @★#≡⊙ MODEL NO. AUX. +VO2 ▲@★#≡⊙ AUX. +VO3 ▲≡#⊙@★ AUX. -VO4 ●⊙★■= Min. Typ. Volt. Max. Typ. Volt. Max. Typ. Volt. Max. Pk. Typ. Volt. Max. Pk. HDC201P-48B-490(E) 2.0A 25A +5V 33A 10A +3.3V 33A 3.0A +12V 5.0A 6.0A 0.5A -12V 1.0A 1.0A HDC201P-48B-490(O) 2.0A 25A +5V 33A 10A +3.3V 33A 3.0A +12V 5.0A 6.0A 0.5A -12V 1.0A 1.0A Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "=" Droop Current Sharing. "≡" 3rd wire Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post-regulator. "■" Common Choke. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 666.0 g (23.5 Oz.) HDC201P-48B-490(E) HDC201P-48B-490(O) INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT DC INPUT ASSIGNMENT -Vin +Vin G CNTR &PIN # 47 46 45 QUAD OUTPUT VO1 S+ S- Adj. C.S. 1,2, 3,4 30 34 29 35 VO2 13,14, 15,16, 17,18 S+ 33 Adj. C.S. 32 Mating connector: PCIH47F400A1. -98- 41 STATUS/CONTROL VO3 S+ C.S VO4 20 36 44 21 DC COM EN# 5,6,7,8,9, 27 10,11,12, 19,22,24 DEG# 38 INH# FAL# 39 42