WP59GYC - Kingbright

T-1 3/4 (5mm) BI-COLOR INDICATOR LAMP
Part Number: WP59GYC
Green
Yellow
Features
Descriptions
z Uniform light output.
z The Green source color devices are made with Gallium
Phosphide Green Light Emitting Diode.
z Low power consumption.
z 3 leads with one common lead.
z The Yellow source color devices are made with Gallium
z Long life-solid state reliability.
Arsenide Phosphide on Gallium Phosphide Yellow Light
z RoHS compliant.
Emitting Diode.
Package Dimensions
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Lead spacing is measured where the leads emerge from the package.
4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 1 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799
Selection Guide
Part No.
Dice
Green (GaP)
WP59GYC
Viewing
Angle [1]
Iv (mcd) [2]
@ 20mA
Lens Type
Min.
Typ.
50
120
40
80
Water Clear
Yellow (GaAsP/GaP)
2θ1/2
24°
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
λpeak
Peak Wavelength
Green
Yellow
λD [1]
Dominant Wavelength
Δλ1/2
Max.
Units
Test Conditions
565
590
nm
IF=20mA
Green
Yellow
568
588
nm
IF=20mA
Spectral Line Half-width
Green
Yellow
30
35
nm
IF=20mA
C
Capacitance
Green
Yellow
15
20
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Green
Yellow
2.2
2.1
2.5
2.5
V
IF=20mA
IR
Reverse Current
Green
Yellow
10
10
uA
VR = 5V
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Green
Yellow
Units
62.5
75
mW
DC Forward Current
25
30
mA
Peak Forward Current [1]
140
140
mA
Power dissipation
Reverse Voltage
5
Operating / Storage Temperature
V
-40°C To +85°C
Lead Solder Temperature [2]
260°C For 3 Seconds
Lead Solder Temperature [3]
260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 2 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799
WP59GYC
Green
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 3 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799
Yellow
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 4 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799
PACKING & LABEL SPECIFICATIONS
WP59GYC
Terms and conditions for the usage of this document
1. The information included in this document reflects representative usage scenarios and is intended for technical reference only.
2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without
notice. Before production usage customer should refer to the latest datasheet for the updated specifications.
3. When using the products referenced in this document, please make sure the product is being operated within the environmental
and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible
for any subsequent issues.
4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has
special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with
Kingbright representative for further assistance.
5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright.
6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 5 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 6 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799
SPEC NO: DSAF2652
REV NO: V.6B
DATE: JAN/20/2015
PAGE: 7 OF 7
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1101005799