WP934FG/2GD - Kingbright

T-1 (3mm) BI-LEVEL LED INDICATOR
Part Number: WP934FG/2GD
Green
Features
Description
z Pre-trimmed leads for pc mounting.
The Green source color devices are made with Gallium
z Black case enhances contrast ratio.
Phosphide Green Light Emitting Diode.
z Wide viewing angle.
z High reliability life measured in years.
z Housing UL rating:94V-0.
z Housing material: type 66 nylon.
z RoHS compliant.
Package Dimensions
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Lead spacing is measured where the leads emerge from the package.
4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.
SPEC NO: DSAF1876
REV NO: V.7B
DATE: MAR/19/2015
PAGE: 1 OF 5
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1102013070
Selection Guide
Part No.
Dice
WP934FG/2GD
Green (GaP)
Viewing
Angle [1]
Iv (mcd) [2]
@ 10mA
Lens Type
Min.
Typ.
2θ1/2
10
25
40°
Green Diffused
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
λpeak
Peak Wavelength
Green
λD [1]
Dominant Wavelength
Δλ1/2
Max.
Units
Test Conditions
565
nm
IF=20mA
Green
568
nm
IF=20mA
Spectral Line Half-width
Green
30
nm
IF=20mA
C
Capacitance
Green
15
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Green
2.2
2.5
V
IF=20mA
IR
Reverse Current
Green
10
uA
VR = 5V
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Green
Units
62.5
mW
DC Forward Current
25
mA
Peak Forward Current [1]
140
mA
5
V
Power dissipation
Reverse Voltage
Operating/Storage Temperature
-40°C To +85°C
Lead Solder Temperature [2]
260°C For 3 Seconds
Lead Solder Temperature [3]
260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
SPEC NO: DSAF1876
REV NO: V.7B
DATE: MAR/19/2015
PAGE: 2 OF 5
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1102013070
Green
WP934FG/2GD
SPEC NO: DSAF1876
REV NO: V.7B
DATE: MAR/19/2015
PAGE: 3 OF 5
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1102013070
PACKING & LABEL SPECIFICATIONS
WP934FG/2GD
Terms and conditions for the usage of this document
1. The information included in this document reflects representative usage scenarios and is intended for technical reference only.
2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without
notice. Before production usage customer should refer to the latest datasheet for the updated specifications.
3. When using the products referenced in this document, please make sure the product is being operated within the environmental
and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible
for any subsequent issues.
4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has
special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with
Kingbright representative for further assistance.
5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright.
6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes
SPEC NO: DSAF1876
REV NO: V.7B
DATE: MAR/19/2015
PAGE: 4 OF 5
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1102013070
SPEC NO: DSAF1876
REV NO: V.7B
DATE: MAR/19/2015
PAGE: 5 OF 5
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: L.Q.Xie
ERP: 1102013070