Specifications

5x5mm SQUARE TOP LED LAMP
Part Number: WP1553IDT
High Efficiency Red
Features
Description
z Low power consumption.
The High Efficiency Red source color devices are made with
z Wide viewing angle.
Gallium Arsenide Phosphide on Gallium Phosphide Orange
z Reliable and rugged.
Light Emitting Diode.
z Excellent uniformity of light output.
z Ideal as flush mounted panel indicators.
z Long life - solid state reliability.
z RoHS compliant.
Package Dimensions
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Lead spacing is measured where the leads emerge from the package.
4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.
SPEC NO: DSAF2624
REV NO: V.3A
DATE: DEC/17/2013
PAGE: 1 OF 6
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: D.N.Huang
ERP: 1101009224
Selection Guide
Part No.
Dice
WP1553IDT
Iv (mcd) [2]
@ 10mA
Lens Type
High Efficiency Red (GaAsP/GaP)
Min.
Typ.
5
10
*2
*5
Red Diffused
Viewing
Angle [1]
2θ1/2
110°
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
*Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
λpeak
Peak Wavelength
High Efficiency Red
λD [1]
Dominant Wavelength
Δλ1/2
Max.
Units
Test Conditions
627
nm
IF=20mA
High Efficiency Red
617
nm
IF=20mA
Spectral Line Half-width
High Efficiency Red
45
nm
IF=20mA
C
Capacitance
High Efficiency Red
15
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
High Efficiency Red
2
2.5
V
IF=20mA
IR
Reverse Current
High Efficiency Red
10
uA
VR = 5V
Notes:
1.Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to the CIE127-2007 compliant national standards.
Absolute Maximum Ratings at TA=25°C
Parameter
High Efficiency Red
Units
Power dissipation
75
mW
DC Forward Current
30
mA
Peak Forward Current [1]
160
mA
5
V
Reverse Voltage
Operating/Storage Temperature
-40°C To +85°C
Lead Solder Temperature [2]
260°C For 3 Seconds
Lead Solder Temperature [3]
260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
SPEC NO: DSAF2624
REV NO: V.3A
DATE: DEC/17/2013
PAGE: 2 OF 6
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: D.N.Huang
ERP: 1101009224
High Efficiency Red
WP1553IDT
SPEC NO: DSAF2624
REV NO: V.3A
DATE: DEC/17/2013
PAGE: 3 OF 6
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: D.N.Huang
ERP: 1101009224
PACKING & LABEL SPECIFICATIONS
WP1553IDT
Terms and conditions for the usage of this document
1.The information included in this document reflects representative usage scenarios and is intended
for technical reference only.
2.The part number, type, and specifications mentioned in this document are subject to future change
and improvement without notice. Before production usage customer should refer to the latest
datasheet for the updated specifications.
3.When using the products referenced in this document, please make sure the product is being
operated within the environmental and electrical limits specified in the datasheet. If customer usage
exceeds the specified limits, Kingbright will not be responsible for any subsequent issues.
4.The information in this document applies to typical usage in consumer electronics applications.
If customer's application has special reliability requirements or have life-threatening liabilities,
such as automotive or medical usage, please consult with Kingbright representative for further
assistance.
5.The contents and information of this document may not be reproduced or re-transmitted without
permission by Kingbright.
6.All design applications should refer to Kingbright application notes available at
http://www.KingbrightUSA.com/ApplicationNotes
SPEC NO: DSAF2624
REV NO: V.3A
DATE: DEC/17/2013
PAGE: 4 OF 6
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: D.N.Huang
ERP: 1101009224
SPEC NO: DSAF2624
REV NO: V.3A
DATE: DEC/17/2013
PAGE: 5 OF 6
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: D.N.Huang
ERP: 1101009224
SPEC NO: DSAF2624
REV NO: V.3A
DATE: DEC/17/2013
PAGE: 6 OF 6
APPROVED: WYNEC
CHECKED: Allen Liu
DRAWN: D.N.Huang
ERP: 1101009224