PASS - Holtek

USB-IF COMPLIANCE PROGRAM
USB 2.0 Test Report
For
Low Speed Device
Company Name:
VID (Dec)
Model Name:
Product Type:
Report Date:
Holtek Semiconductor Inc.
04D9 The VID for the company who apply the USB-IF logo.
HT82B40R
USB Keyboard
04/27/2010
Test Result: PASS
Tester:
Homer Hung
Authorized Signature:
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
1/9
USB-IF COMPLIANCE PROGRAM
Legal Disclaimer
1.
TEST RESULT IS VALID ONLY TO THE ORIGINAL TESTED DEVICE MODEL. ALLION
RESERVES THE RIGHT TO PROHIBIT OTHERS TO DISTORT, ISOLATE, FALSIFY,
COPIED AND/OR BY ANY PROCESS TO CHANGE THE CONTENT OF THIS TEST
REPORT UNLESS IT IS PRIOR APPROVED BY ALLION.
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
2/9
USB-IF COMPLIANCE PROGRAM
Legacy USB Compliance Tests
Pass
Frameworks Test Result:
Fail
This test primarily covers USB-IF testing of devices and hubs for compliance with the standard
commands in Chapters 9 and 11 of the USB 2.0 specification. This specification does not
describe the full set of USB-IF tests and assertions for these devices.
Chapter 9:
VID: 04d9
PID: 0d40
Chapter 9:
Pass
Fail
HID View:
Pass
Fail
N/A
Interface: 1 MAX Power: 100 mA
Power Current Test Result:
Remote Wakeup: Yes
Pass
Fail
Power Type: Low Powered Device
Operating Power: 27.9 mA
Unconfiguration Power: 14.4 mA
(<= Max Power <= 100mA for Low Power)
(<= Max Power <= 100mA for Self Power)
(<= Max Power <= 500mA for High Power)
(<= 100mA)
Configuration Power: 14.4 mA
Suspend Mode Power with Remote Wake Up: 350 uA
Suspend Mode Power without Remote Wake Up: 350 uA
(<= Max Power <= 100mA for Low Power)
(<= Max Power <= 500mA for High Power)
(<= 2500uA)
Suspend Port Power: 350 uA
(<= 2500uA for not Supporting USB Battery Charging)
(<= 100mA for Supporting USB Battery Charging)
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
3/9
USB-IF COMPLIANCE PROGRAM
Interoperability Test Overall Result:
Pass
Fail
EHCI Controller:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Enumeration and Driver installation:
Check operation of device
Interoperability – Operate all device:
Hot plug test
Warm Boot test
Remote Wake-up test
S3 Active Standby Test
S3 Active Standby Resume Test
Root Port Test
S4 Active Hibernate Test
S4 Active Hibernate Resume Test
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Fail
Pass
Fail
Pass
Fail
N/A
UHCI Controller:
12. Interoperability – Operate all device:
OHCI Controller:
13. Interoperability – Operate all device:
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
4/9
USB-IF COMPLIANCE PROGRAM
Full Signal Quality Test Result:
Pass
Fail
Connector Type: Untethered (Tethered mean no standard B or special B connector)
Low Speed UP Stream Signal Quality:
Pass
Fail
Inrush Current Test:
Pass
Fail
Back Voltage Test Result: (Enumerate before/after)
Pass
Fail
D+: 0 mV / 0 mV
D- : 0 mV / 0 mV
VBus: 0 mV / 0 mV
(All values <= 400mV)
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
5/9
USB-IF COMPLIANCE PROGRAM
With USB 3.0 PDK (NEC D720200xHCI):
All USB 2.0 peripherals seeking certification are required to demonstrate enumeration on the
USB 3.0 PDK. Failure to enumerate and pass the USB 2.0 Chapter 9 Device Framework tests
in USB30CV will prevent certification
Frameworks Test Result:
Chapter 9:
Pass
Pass
Fail
Fail
Interface: 1 MAX Power: 100 mA
Remote Wakeup: Yes
MSC Test:
Pass
Fail
N/A
UVC Test:
Pass
Fail
N/A
HID Test:
Pass
Fail
N/A
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
6/9
USB-IF COMPLIANCE PROGRAM
More Detail Test Result:
1. Low Speed Upstream Signal Quality: Pass






Overall result: pass!
Signal eye:
eye passes
EOP width: 1.33 s
EOP width passes
Measured signaling rate: 1.5032 MHz
signal rate passes
Crossover voltage range: 1.69 V to 1.82 V, mean crossover 1.75 V
(first crossover at 1.73 V, 10 other differential crossovers checked)
crossover voltages pass
Consecutive jitter range: -1.166 ns to 1.021 ns, RMS jitter 0.760 ns
Paired JK jitter range: 0.647 ns to 0.980 ns, RMS jitter 0.830 ns
Paired KJ jitter range: -1.120 ns to 1.236 ns, RMS jitter 0.959 ns
jitter passes
Additional Information



Rising Edge Rate: 17.43 V/us (Equivalent risetime = 151.46 ns)
(minimum 8.80 V/us, maximum 35.20 V/us)
Falling Edge Rate: 13.94 V/us (Equivalent risetime = 189.40 ns)
(minimum 8.80 V/us, maximum 35.20 V/us)
Edge Rate Match: 25.05% (limit +/-20%)
Signal Data and Eye
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
7/9
USB-IF COMPLIANCE PROGRAM
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
8/9
USB-IF COMPLIANCE PROGRAM
2. Inrush Current: Pass



Overall result: pass!
Inrush at 5.000 V: 17.77 C
inrush passes
Region 1 Start: 0.00101 ms - End: 0.23 ms = 17.77 C
Hot Plug (Attach) Current Draw
Notice: Test result is valid only to the original tested device model. The content
of test report may not be copied or re-transmitted (except for the entire
report) unless it is prior approved by Allion.
Test Procedure Reference:
1. Universal Serial Bus Implementers Forum Full and Low Speed Electrical and
Interoperability Compliance Test Procedure, version: 1.3
2. Universal Serial Bus Implementers Forum Device High-speed Electrical Test
Procedure For Tektronix Test Equipment, version: 1.0
3. Universal Serial Bus Implementers Forum Device High-speed Electrical Test
Procedure, version: 1.0
Project ID:KB-HOK-USB-006_1
© Allion Test Labs, Inc. All rights reserved.
9F, No. 3-1, Yuan Ku Street, Taipei, Taiwan, 11503, R.O.C.
Phone: +886-2-77228800 Fax: +886-2-26557879
9/9