MCC
ER3AB
TM
Micro Commercial Components
omponents
20736 Marilla Street Chatsworth
!"#
$
% !"#
THRU
ER3MB
Features
•
•
•
•
•
•
•
Maximum Ratings
•
•
•
3 Amp Super Fast
Recovery
Silicon Rectifier
50 to 1000 Volts
Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates
Compliant. See ordering information)
Epoxy meets UL 94 V-0 flammability rating
Moisture Sensitivity Level 1
Easy Pick And Place
High Temp Soldering: 260°C for 10 Seconds At Terminals
Super Fast Recovery Times For High Effieciency
Halogen free available upon request by adding suffix "-HF"
Operating Temperature: -50°C to +150°C
Storage Temperature: -50°C to +150°C
Typical Thermal Resistance; 16 °C/W Junction To Lead
MCC
Device
Maximum
Maximum Maximum
Catalog
Marking
Recurrent
RMS
DC
Number
Peak Reverse
Voltage
Blocking
Voltage
Voltage
ER3AB
ER3AB
50V
35V
50V
ER3BB
ER3BB
100V
70V
100V
ER3CB
ER3CB
150V
105V
150V
ER3DB
ER3DB
200V
140V
200V
ER3GB
ER3GB
400V
280V
400V
ER3JB
ER3JB
600V
420V
600V
ER3KB
ER3KB
800V
560V
800V
1000V
700V
1000V
ER3MB
ER3MB
DO-214AA
(SMB) (LEAD FRAME)
H
J
A
E
Electrical Characteristics @ 25°C Unless Otherwise Specified
Average Forward
Current
Peak Forward Surge
Current
Maximum
Instantaneous
Forward Voltage
ER3AB-3DB
ER3GB
ER3JB~3MB
Maximum DC
Reverse Current At
Rated DC Blocking
Voltage
Maximum Reverse
Recovery Time
ER3AB~ER3JB
ER3KB~ER3MB
IF(AV)
3.0A
D
100A
8.3ms, half sine
VF
.95V
1.25V
1.70V
IFM = 3.0A;
TJ = 25°C*
5µA
200µA
TJ = 25°C
TJ = 100°C
B
G
TA = 75°C
IFSM
C
DIMENSIONS
DIM
A
B
C
D
E
G
H
J
INCHES
MIN
.075
.077
.002
----.030
.200
.160
.130
MM
MIN
1.91
1.96
.05
----.76
5.08
4.06
3.30
MAX
.095
.083
.008
.02
.060
.220
.187
.155
MAX
2.41
2.10
.20
.51
1.52
5.59
4.75
3.94
NOTE
SUGGESTED SOLDER
PAD LAYOUT
0.090"
IR
35ns
Trr
IF=0.5A, IR=1.0A,
Irr=0.25A
0.085”
75ns
0.070”
Typical Junction
CJ
45pF
Measured at
Capacitance
1.0MHz, VR=4.0V
*Pulse test: Pulse width 300 µsec, Duty cycle 2%
www.mccsemi.com
1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7.
Revision: B
1 of 4
2013/01/01
MCC
ER3AB thru ER3MB
Figure 1
Typical Forward Characteristics
TM
Micro Commercial Components
100
Figure 2
Forward Derating Curve
60
3.0
40
ER3AB-3DB
20
2.5
ER33GB
10
2.0
6
ER3JB~3MB
4
1.5
Amps
2
1.0
TJ =25°C
Amps
1
.5
Single Phase, Half Wave
60Hz Resistive or Inductive Load
.6
.4
0
40
60
80
100
120
140
160
.2
°C
.1
Average Forward Rectified Current - Amperesversus
Lead Temperature -°C
.06
.04
.02
.01
.4
.6
.8
1.0
1.2
1.6
1.4
Volts
Instantaneous Forward Current - Amperesversus
Instantaneous Forward Voltage - Volts
Figure 3
Typical Junction Capacitance
100
60
40
20
pF
TJ=25°C
10
6
4
2
1
.1
.2
.4
1
Volts
2
4
10
20
40
100
200
400
1000
Junction Capacitance - pFversus
Reverse Voltage - Volts
Revision: B
www.mccsemi.com
2 of 4
2013/01/01
MCC
ER3AB thru ER3MB
Figure 4
Typical Reverse Characteristics
Micro Commercial Components
1000
600
Figure 5
Peak Forward Surge Current
150
400
200
125
TJ=100°C
100
100
60
75
40
Amps
50
20
25
µAmps 10
0
6
4
1
2
6
4
8 10
20
40
60 80 100
Cycles
TJ=75°C
Peak Forward Surge Current - Amperesversus
Number Of Cycles At 60Hz - Cycles
2
1
.6
.4
TJ=25°C
.2
.1
20
40
60
80
100
120
140
Volts
Instantaneous Reverse Leakage Current - MicroAmperesversus
Percent Of Rated Peak Reverse Voltage - Volts
Figure 6
Reverse Recovery Time Characteristic And Test Circuit Diagram
50Ω
10Ω
trr
+0.5A
0
Pulse
Generator
Note 2
25Vdc
1Ω
Oscilloscope
Note 1
-1.0
1cm
Set Time Base for 20/100ns/cm
Notes:
1. Rise Time = 7ns max.
Input impedance = 1 megohm, 22pF
2. Rise Time = 10ns max.
Source impedance = 50 ohms
3. Resistors are non-inductive
Revision: B
-0.25
www.mccsemi.com
3 of 4
2013/01/01
TM
MCC
TM
Micro Commercial Components
Ordering Information :
Device
Packing
Part Number-TP
Tape&Reel: 3Kpcs/Reel
Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF
***IMPORTANT NOTICE***
Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to
make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components
Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it
convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all
risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are
represented on our website, harmless against all damages.
***LIFE SUPPORT***
MCC's products are not authorized for use as critical components in life support devices or systems without the express written
approval of Micro Commercial Components Corporation.
***CUSTOMER AWARENESS***
Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking
strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages
customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on
our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine
parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty
coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global
problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized
distributors.
www.mccsemi.com
Revision: B
4 of 4
2013/01/01