Single Output DIN RAIL Power Supply IS-120 Series, 120Watt FEATURES: Input voltage range 100-240VAC Installation on DIN rail 30mm only High reliability Built-in EMI filter Short circuit, over current, over voltage protections Cooling by free air convection 100% burn-in test LED indicator for DC power ON LED indicator for DC low 3 year warranty Model IS120-24 IS120-48 Input voltage (Vac) 100-240 Output voltage (Vdc) Output current (A) Efficiency Typ. 24 5 87% 48 2.5 88% ELECTRICAL Input Parameters Symbols Test Conditions / Comment Input voltage Vin -- Input frequency Fline Inrush current Input current Turn-on delay time www.pairuigroup.com Min. Typ. Max. Units 88 -- 264 Vac 125 -- 370 Vdc -- 47 -- 63 Hz Cold start, Vin =115Vac,full load -- 20 -- A Cold start, Vin =230Vac,full load -- 40 -- A Full load, Vin =115Vac -- 2.0 -- A Full load, Vin =230Vac -- 1.0 -- A Full load, Vin =115Vac -- -- 0.56 S Iinrush Iin Ton_delay Page: 1 / 3 Date: 03/08/2014 Single Output DIN RAIL Power Supply IS-120 Series, 120Watt ELECTRICAL Output Parameters Symbols Test Conditions / Comment Min. Typ. Max. Units -- -- -10 -- +20 % Line regulation Iout-line -- -- 1 -- % Load regulation Iout-load Vout from min. to max. -- 1 -- % Hold-on time -- Full load, Vin =115Vac -- 20 -- ms Ripple -- -- -- 120 150 mV Voltage adjustment range Protection Over current Type:110-150%; Hiccup mode, it will recover automatically after fault conditions remove Short circuit Hiccup mode, it will recover automatically after fault conditions remove Over voltage Type:110-150%; Hiccup mode, it will recover automatically after fault conditions remove DC-OK Lamp LED(Green) DC-Low Lamp LED(Red) Parallel/series operation Series operations is possible Environment Storage Ambient operating temperature Operating relative humidity MTBF Tstorage Ta Humidity: 5% RH to 95% RH Startup at rated voltage (Required Derating) Ha TMTBF Non condensing Full load, 230Vac input, ℃ ambient temperature 25 Dimension(WxHxD) -40 -- +85 ℃ -25 -- +70 ℃ 20 -- 95 % -- -- 200 kHrs 40x130x125mm Safety / EMC Withstand voltage I/P-O/P: 3KVac Safety standards UL, C-UL, CE, CB www.pairuigroup.com I/P-FG: 2KVac O/P-FG: 0.5KVac Page: 2 / 3 Date: 03/08/2014 Single Output DIN RAIL Power Supply IS-120 Series, 120Watt ELECTRICAL EMC EN55011/EN55022-B, FCC-B THD EN61000-3-2(Class-A) EMC FCC Part 15 Class B, VCCI-B, CLSPR22-B,EN55022-B THD EN61000-3-2(Class-A) Notes: 1. Rated Load and Rated Input Voltage,Ta=25℃; 2. Ripple &Noise are measured at 20MHZ of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uF parallel capacitor. MECHANICAL 125 ±1 . 0 40 ±1 . 0 1 5 5 5 OUTPUT VOLTAGE ADJUSTER 35mm ) LED ( DC OK ) . LED ( DC LOW ) . 115 0 5 130 1 0 7 8 : 47 5 DIN Rail ( Width . 35 ± ± 12 . 3 47 5 79 PRINTING . 6 NAME PLATE 7. 5 7. 5 8Max. 110 . 4 14 . 7 U nit: mm Tolerance : www.pairuigroup.com Page: 3 / 3 ±1 Date: 03/08/2014