PI6C18551 3.3V/5V, 160 MHz, 4 output, CMOS Clock Buffer Features Description • • • • • • • PI6C18551 is a low skew, low noise and high-speed clock buffer for computing, networking and communication applications. It is a non-inverting buffer with four outputs from a single input. The outputs are controlled by output enable pin (OE), outputs are tri-states when OE is LOW, and outputs are enabled when OE is HIGH. 160 MHz maximum frequency Low skew: 250ps Fast rise/fall time: 1.5ns Output Enable with tri-states Industrial Temperature 3.3V or 5V power supply Packaging (Pb-free & Green available): −8-pin SOIC (W) Pin Description Applications • • • • • 33 MHz for PCI 106.25 MHz for Fibre Channel 125 MHz for Ethernet 133 MHz for PCIX 155.52 MHz for OC3/SONET CLK_IN 1 8 OE* Y0 2 7 VDD Y1 3 6 GND Y2 4 5 Y3 *External pull-up recommended Logic Block Diagram Y0 Function Table Inputs Y1 Y2 CLK_IN Y3 OE 10-0157 Outputs CLK_IN OE Y[3:0] X L Z L H L H H H Note: 1. X = Don't Care; Z = Tri-state 1 PS8733E 04/20/10 PI6C18551 3.3V/5V, 160 MHz, 4 output, CMOS Clock Buffer Pin Description Pin Name Type Pin No Descriptions CLK_IN Input 1 Input clock with pull-up resistor Y0 Output 2 Output clock Y1 Output 3 Output clock Y2 Output 4 Output clock Y3 Output 5 Output clock GND Ground 6 GROUND VDD Power 7 3.3V or 5V power supply OE Input 8 Output Enable with pull-up resistor. External pull-up resistor is recommended. External Components A minimum number of external components are required for proper operation. A decoupling capacitor of 0.01μF should be connected between VDD on pin 7 and GND on pin 6, as close to the device as possible. A 33-Ohm series terminating resistor may be used on each clock output if the trace is longer than 1 inch. An external 100k-Ohm pull-up resistor should be used on pin 8, OE. Absolute Maximun Ratings (Over operating free-air temperature range) Symbol VDD Parameters Min. Supply Voltage Max. Units 7 VI Input Voltage -0.5 VDD+0.5 VO Output Voltage -0.5 VDD+0.5 Ts Storage Temperature -65 150 Ta Ambient Temperature -40 85 Tso Soldering Temperature 10-0157 V °C 260 2 PS8733E 04/20/10 PI6C18551 3.3V/5V, 160 MHz, 4 output, CMOS Clock Buffer DC Electrical Characteristics (VDD = 3.3V ±5%, TA = -40 to 85°C) Symbol Parameters Condition VDD 3.3V I/O Supply Voltage VIH Input High Voltage VIL Input Low Voltage VOH Output High Voltage IOH = -12mA VOL Output Low Voltage IOL = 12mA IDD Power Supply Current ZO Output Impedance RPU Internal Pull-up Resistor IOS Short Circuit Current Min. Typ. Max. 3.135 3.465 CLK_IN, Note 1 VDD/2 + 0.7 3.8 OE 2 VDD CLK_IN, Note 1 VDD/2 - 0.7 OE 0.8 No load at 135 MHz CLK_IN & OE Units V 2.4 0.4 34 mA 20 Ohm 192 kOhm −46 mA Notes: 1. Nominal switching threshold is VDD/2 10-0157 3 PS8733E 04/20/10 PI6C18551 3.3V/5V, 160 MHz, 4 output, CMOS Clock Buffer DC Electrical Characteristics (VDD = 5V ±5%, TA = -40 to 85°C) Symbol Parameters VDD 5V I/O Supply Voltage VIH Input High Voltage VIL Input Low Voltage VOL Condition Min. Typ. Max. 4.75 5.25 CLK_IN, Note 1 VDD/2 + 1 5.5 OE 2 VDD CLK_IN, Note 1 VDD/2 - 1 OE 0.8 Output Low Voltage IOL = 12mA 0.4 VOH Output High Voltage (CMOS Level) IOH = -12mA IDD Power Supply Current No load at 135MHz ZO Output Impedance RPU Internal Pull-up Resistor IOS Short Circuit Current Units V 4 CLK_IN & OE 61 mA 20 Ohm 193 k-Ohm −90 mA Notes: 1. Nominal switching threshold is VDD/2 AC Electrical Characteristics (VDD = 3.3±5%, TA = -40 to 85°C) Symbol Parameters Fin Input Frequency Fo Output Frequency Condition Min. Typ. 0 160 load(5) Fo Output Frequency TR Rise Time 0.8V to 2.0V 1.5 TF Fall Time 2.0V to 0.8V 1.5 TPD Propagation Delay TPD Propagation Delay TSK Output Skew Tjit Additive Jitter 3.3V, 135MHz(2) 5V, 135MHz(2) VDD MHz 135 2 4 8 1.5 3 6 /2(3) RMS @ 12KHz~20MHz Units 160 3.3V, 15pF load(5) 5V, l5pF Max. 250 45.6 ns ps fs Notes: 1. With rail to rail input clock. 2. All outputs with equal loading. 3. Duty cycle on outputs will match incoming clock duty cycle. 4. With external series resistor 33Ω positioned close to each output pin. 10-0157 4 PS8733E 04/20/10 PI6C18551 3.3V/5V, 160 MHz, 4 output, CMOS Clock Buffer Jitter (RMS @ 12KHz~20MHz) Output phase noise vs. input (light blue line) plot Output RMS phase jitter=156.4fs Input phase noise plot Input RMS phase jitter=149.6fs 10-0157 5 PS8733E 04/20/10 PI6C18551 3.3V/5V, 160 MHz, 4 output, CMOS Clock Buffer Packaging Mechcanical: 8-pin SOIC (W) DOCUMENT CONTROL NO. 8 PD - 1001 REVISION: F .149 .157 DATE: 03/09/05 3.78 3.99 .0099 .0196 0.25 x 45˚ 0.50 1 .189 .196 4.80 5.00 .0075 .0098 0-8˚ 0.19 0.25 0.40 .016 1.27 .050 1 .016 .026 0.406 0.660 .2284 .2440 5.80 6.20 .053 1.35 .068 1.75 SEATING PLANE REF .050 BSC 1.27 .0040 0.10 .0098 0.25 .013 0.330 .020 0.508 Pericom Semiconductor Corporation 3545 N. 1st Street, San Jose, CA 95134 1-800-435-2335 • www.pericom.com X.XX DENOTES DIMENSIONS X.XX IN MILLIMETERS Notes: 1) Controlling dimensions in millimeters. 2) Ref: JEDEC MS-012D/AA DESCRIPTION: 8-Pin, 150-Mil Wide, SOIC PACKAGE CODE: W Ordering Information(1,2,3): Ordering Code PI6C18551WE Package Code Package Description W Pb-free & Green, 8-pin SOIC Notes: 1. Thermal characteristics can be found on the company web site at www.pericom.com/packaging/ 2. E = Pb-free and Green 3. Adding an X Suffix = Tape/Reel Pericom Semiconductor Corporation • 1-800-435-2336 • www.pericom.com 10-0157 6 PS8733E 04/20/10