M3T-DCT42B-450 Direct Dummy IC for 42-pin 0.8mm-pitch SSOP Dimensions Function This accessory tool connects an emulation pod and the target. It can be mounted on the same foot pattern as the MCU housed in the 42-pin 0.8mm-pitch SSOP (42P2R-A) package. Attaching Procedure This converter can be used during debugging and board-mounted evaluation in common. When debugging (1) Mount this dummy IC on the foot pattern. (2) Mount a converter (e.g. M3T-FLX-DCT503) on top of (1). (3) Then connect the emulation pod to the connector provided on the converter. Also, when using an emulator MCU housed in the 42-pin 1.778mm-pitch SDIP (42P4B or 42S1B-A), use the converter M3T-42DIP-DMS between the MCU and the M3T-DCT42B-450. During board-mounted evaluation Attach the converter M3T-42DIP-DMS to the dummy IC (M3T-DCT42B-450) on the target system. ① denotes pin numbers on the M3T-DCT42B−450. 1 denotes pin numbers of the top of a connector. Symbol Term Dimensions [mm] A Fitting height 5.0 D Package length 11.8 E Package width 17.5 e Interval in row of pins 0.8 Foot Pattern Reference Dimensions See Appendix D "Reference Dimensional Drawings for SSOP Package Foot Pattern Made by Matsushita Electric Works, Ltd." [Ordering Information] See Appendix H "Ordering Information". * : Position of No. 1 pin * When using the emulation pod M37515T-RPD, the converter M3T-FLX-DCT503 is required. *All brand names and product names are trademarks or registered trademarks of their respective companies.