DX8020 ASSEMBLING INSTRUCTION Moscow 2010 Complete set of DX8020 Measuring Stand Electronic Block Vacuum Station with Turbo pump Vacuum pipe Power cables/Three Signal Cables/Three Vacuum gauge with cable and special connector Alarm cables/Two RS232 cable Fixture/Four Clamps/Three Vacuum Interconnector Sealing rings/One large, three small 1. Take Vacuum Station 2. Remove cover from top 3. Put large vacuum seal ring Seal ring 4. Put vacuum interconnector 5. Mount interconnector with use of four vacuum fixtures Fixtures ring 6. Put small vacuum seal ring Seal ring 7. Mount vacuum valve with use of vacuum clamp 8. Connect vacuum pipe with use of vacuum clamp 9. Place vacuum stand near vacuum pump station Cover 10. Remove cover from flange of vacuum pipeline 11. Connect other side of vacuum pump to flange onto measuring stand 12. Take cables: Three signal cables marked red, gray and blue 13. Two alarm cables marked yellow and red 14. Three power cables marked brown, white and yellow 15. RS232 cable 16. Last cable with special connector is already mounted to vacuum gauge Cable with special connector 17. Take electronic block. Back side. Connect yellow alarm cable 18. Connect red signal cable 19. Connect gray signal cable 20. Connect RS232 cable 21. Connect blue signal cable 22. Connect red alarm cable 23. Connect yellow power cable 25. Connect white power cable to measuring stand 26. Connect brown power cable between vacuum pump and measuring stand 27. Connect cable with special connector of vacuum gauge to measuring stand. 28. Look and the left of front of measurtinmg stand. Connect yellow alarm cable 29. Look and the left of front of measurtinmg stand. Connect red alarm cable 30. Look from bottom of measuring stand. Connect blue sygnal cable as shown Connector for blue cable 31. Look from right side measuring stand. Connect red sygnal cable as shown Connector for red cable 32. Look from bottom of measuring stand. Connect gray sygnal cable as shown Connector for gray cable 33. The DX8020 syspem is completed. Connect it to power suppy by white and yeallow power cables. 34. Switch On Electronic Block 35. Switch On Measuring Stand. Puch “Start” button. Vacuu pump will start working 36. Look at the screen of vacuum gauge to monitor vacuum inside measuring chamber Vacuum gauge 37. At vacuum about 5x10-3 topp system is ready for operation (measurements). Look into Device Manual for order of operation. System ready LED 38. After finish of working to stop system: Push “Stop” button for few second… “Stop” button 39. … until yellow LED will light. Vacuum pump will finish working – stopping of turpo pump rotation. Yellow LED 40. Switch Off Measing Stand and Electronic Block