MW시리즈 2015.1.20 03:55 PM 페이지1 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI MINIATURE ALUMINUM ELECTROLYTIC CAPACITORS MW High ripple current Series ・Load life of 5000 hours at 105° C ・Voltage range 25V ~ 450V ・Complied to the RoHS directive Item Characteristics Operating temperature range -40 ~ +105° C WV≤100 I = 0.01CV or 3μ A whichever is greater (after 2 min.) I = 0.03CV or 4μ A whichever is greater (after 1 min.) Leakage current max. Capacitance tolerance WV > 100 I = 0.02CV+25μ A (after 5 min.) ±20% at 120Hz, 20° C WV tanδ Dissipation factor max. (at 120Hz, 20° C) Low temperature characteristics (Impedance ratio at 120Hz) 25 0.14 50 0.10 160 0.15 200 0.15 250 0.15 350 0.20 400 0.24 450 0.24 WV 25 35 50 160 200 250 350 400 450 Z-25° C/Z+20° C 2 2 2 3 3 4 4 6 6 Z-40° C/Z+20° C 3 3 3 4 4 4 8 10 10 After an application of DC bias voltage plus the rated AC ripple current for 2000 hours at 105° C. The measurement shall meet the following limits. The DC voltage plus the peak AC voltage combined must not exceed the rated voltage. Rated voltage (Vdc) Capacitance change tanδ Leakage current Load life 35 0.12 25 ~ 50 160 ~ 450 Within ±25% of initial value Within ±20% of initial value Less than 200% of specified value Less than specified value After 1000 hours no load test, leakage current, capacitance and tanδare same as load life value. The measurement shall be performed at 20° C by the KS C IEC 60384 - 4 Shelf life (at 105° C) Unit : mm ● DRAWING Ød±0.05 Tinned copper-ply wire + P±0.5 - L+βmax. 15 min. ØD 10 P 5.0 Ød 0.6 β 4 min. Safety vent 120kHz Rated ripple current(mArms / 105° C) 50kHz 100kHz 470 628 1987 2092 35 330 588 1862 1960 Vdc Cap.(μF) 25 ØD× ×L (mm) 50 220 495 1568 1650 160 27 192 608 640 200 22 179 565 595 250 6.8 102 323 340 250 15 153 485 510 350 10 125 394 415 400 8.2 108 342 360 450 3.3 92 292 307 10×12.5 1.0 MINIATURE TYPES ØD+0.5 max. Insulating sleeve