TD3051 Random Phase Switching 600V Triac Driver Description Features The TD3051 consists of a single input AlGaAs LED optically coupled to a Random Phase triac driver chip. The TD3051 provides high input-to-output isolation and is designed to drive high-powered triacs. Typical uses include interfacing logic level control signals to equipment powered from 110VAC to 240VAC lines. The TD3051 comes standard in a miniature 6 pin DIP package making it ideal for high-density board applications. Random Phase Switching 600V Blocking Voltage Trigger Current (15mA MAX) High Isolation Voltage (5000VRMS) High dV/dt (1kV/S MIN) Long Life / High Reliability RoHS / Pb-Free / REACH Compliant Agency Approvals UL/C-UL: VDE: Applications Home Appliances Motor / Drive Controls Solid State Relays Solenoid / Valve Controls Temperature Controls Dimmer Controls Absolute Maximum Ratings The values indicated are absolute stress ratings. Functional operation of the device is not implied at these or any conditions in excess of those defined in electrical characteristics section of this document. Exposure to absolute Maximum Ratings may cause permanent damage to the device and may adversely affect reliability. Schematic Diagram Storage Temperature …………………………..-55 to +125°C Operating Temperature …….………...………-40 to +100°C Continuous Input Current ………………………………..50mA Transient Input Current ………………….……………..400mA Reverse Input Control Voltage …………..…………………5V Input Power Dissipation …………………………………40mW Output Power Dissipation ……………………………..330mW Solder Temperature – Wave (10sec)……………….….260°C Solder Temperature – IR Reflow (10sec)….…………..260°C (+) Input 1 6 +/- Load (-) Input 2 5 Do Not Connect (Triac Substrate) Random Phase Circuit Do Not Connect 3 File # E201932 File # 40035191 (EN 60747-5-2) Ordering Information 4 -/+ Load Part Number TD3051 TD3051-H TD3051-S TD3051-STR TD3051 Description 6 pin DIP, (60/Tube) 0.40” (10.16mm) Lead Spacing (VDE0884) 6 pin SMD, (60/Tube) 6 pin SMD, Tape and Reel (1000/Reel) NOTE: Suffixes listed above are not included in marking on device for part number identification © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Page 1 of 9 TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver Electrical Characteristics, TA = 25°C (unless otherwise specified) Parameter Symbol Min. Typ. Max. 1.8 Units Test Conditions Input Specifications LED Forward Voltage LED Reverse Voltage VF - 1.4 V IF = 10mA BVR 5 - - V IR = 10μA IInRleak - - 10 A VR = 5μA IInOn - - 15 mA Main Terminal Voltage = 3V Blocking Voltage VDRM 600 - - V Peak Blocking Current IDRM1 - 10 100 nA VDRM = 600 IO - - 100 mA IF = 15mA On-State Voltage VON - 2 3 V IF = 15mA, ITM = 100mA Leakage Current IDRM2 - 0.2 1 A IF=0mA, VDRM = 600V Holding Current IHOLD - 250 - A - dV/dt 1,000 1,500 - V/S - Isolation Voltage VISO 5,000 - - VRMS Input-Output Resistance RI-O - - Reverse Leakage Current Trigger Current 1 Output Specifications Continuous Load Current Critical Rate of Rise 2 IO = 1A Isolation Specifications 10 12 Note 1: Resistive load. For inductive loads, higher drive current is recommended Note 2: This is for static dV/dt. Test Circuit Below RH ≤ 50%, t=1min VI-O = 500VDC TD3051 Static dV/dt Test Circuit: © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Page 2 of 9 TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Performance & Characteristics Plots, TA = 25°C (unless otherwise specified) Figure 3: On-State Characteristics Figure 4: Leakage Current (IoLEAK) vs. Temperature (°C) Figure 5: Turn On Current (IF) vs. Temperature (°C) © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Page 3 of 9 TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Solder Temperature Profile Recommendations (1) Infrared Reflow: Refer to the following figure as an example of an optimal temperature profile for single occurrence infrared reflow. Soldering process should not exceed temperature or time limits expressed herein. Surface temperature of device package should not exceed 250ºC: G F D E H B A C Figure 1 Process Step A B C D E F G H Description Preheat Start Temperature (ºC) Preheat Finish Temperature (ºC) Preheat Time (s) Melting Temperature (ºC) Time above Melting Temperature (s) Peak Temperature, at Terminal (ºC) Dwell Time at Peak Temperature (s) Cool-down (ºC/s) Parameter 150ºC 180ºC 90 - 120s 230ºC 30s 260ºC 10s <6ºC/s (2) Wave Solder: Maximum Temperature: Maximum Time: Pre-heating: Single Occurrence 260ºC (at terminal) 10s 100 - 150ºC (30 - 90s) (3) Hand Solder: Maximum Temperature: Maximum Time: Single Occurrence © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 350ºC 3s (at tip of soldering iron) Page 4 of 9 TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Package Dimensions 6 PIN DIP Package © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Note: Page 5 of 9 All dimensions in millimeters with inches [“] in parenthesis () TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Package Dimensions 6 PIN WIDE Lead Space Package (-H) © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Note: All dimensions in millimeters [mm] with inches in parenthesis () Page 6 of 9 TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Package Dimensions 6 PIN SMD Surface Mount Package (-S) © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Note: Page 7 of 9 All dimensions in millimeters with inches [“] in parenthesis () TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Package Dimensions 6 PIN SMD Tape & Reel (-STR) © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Note: Page 8 of 9 All dimensions in millimeters TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695 TD3051 Random Phase Switching 600V Triac Driver TD3051 Package Marking TD3051 YYWW Date Code Pin 1 TD3051 Package Weights Single Unit Full Tube (60pcs) Full Pouch (10 tubes) Full Reel (1000pcs) TD3051 0.41 43 450 - TD3051-S 0.40 42 440 - TD3051-H 0.42 44 460 TD3051-STR 0.40 - - Device Note: 880 All weights above are in GRAMS, and include packaging materials where applicable DISCLAIMER Solid State Optronics (SSO) makes no warranties or representations with regards to the completeness and accuracy of this document. SSO reserves the right to make changes to product description, specifications at any time without further notices. SSO shall not assume any liability arising out of the application or use of any product or circuit described herein. Neither circuit patent licenses nor indemnity are expressed or implied. Except as specified in SSO’s Standard Terms & Conditions, SSO disclaims liability for consequential or other damage, and we make no other warranty, expressed or implied, including merchantability and fitness for particular use. LIFE SUPPORT POLICY SSO does not authorize use of its devices in life support applications wherein failure or malfunction of a device may lead to personal injury or death. Users of SSO devices in life support applications assume all risks of such use and agree to indemnify SSO against any and all damages resulting from such use. Life support devices are defined as devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when used properly in accordance with instructions for use can be reasonably expected to result in significant injury to the user, or (d) a critical component of a life support device or system whose failure can be reasonably expected to cause failure of the life support device or system, or to affect its safety or effectiveness. © 2013 Solid State Optronics • San José, CA www.ssousa.com • +1.408.293.4600 Page 9 of 9 TD3051 /H/S/TR Rev 2.01 (11/12/2013) 001695