BP5726-15 Non-isolated AC/DC Converter AC 220V input, 15V/800mA output Absolute Maximum Ratings Dimensions (mm) Unit V V mA W Tcmax 105 °C Topr −25 to +80 °C −40 to +105 °C Tstg Conditions 22.5 MAX. Ambient temperature + module self-heating Tcmax 7.8 MAX. 27.1 MAX. Limits 800 24 400 12 4.0±1.0 Symbol VD VFB ID Po Mark side Parameter 7-pin input voltage 4-pin input voltage 7-pin input Current Maximum power Allowable maximum surface temperature Operating temperature range Storage temperature range 3.25 MAX. 1 2 3 4 5 7 0.5±0.1 1.3±0.2 P=2.54±0.2 0.25±0.05 5.55 MAX. 2.54x6=15.24(TYP.) Derating Curve Electrical Characteristics Symbol Vo Io Min. 14.0 0 Typ. 15.0 − Max. 16.0 800 Unit V mA Line regulation Vr VI Vp − − − 30 80 150 150 500 500 mV mV mVpp η1 75 85 − % η2 35 49 − % Io=20mA Be sure to use fuse for safety. T1 Vin+ C2 C1 D2 C3 Vo:15V/400mA Pin No. Name 1 Vo 2 Vo 3 Vin(-) 4 VFB 5 Vs 7 VD + R1 + R2 D1 GND Vo:12V/500mA D3 -30-20-10 0 10 20 30 40 50 60 70 80 90 Ambient Temperature Ta(°C) Function This is the output detection terminal. This is the output detection terminal. This is the primary side input minus terminal. Feedback terminal This is the start terminal. Connect this via the external resistor (750kΩ) to Vi (+). 100 90 80 70 60 50 40 30 20 10 0 0 100 200 300 400 500 600 700 800 900 1000 Output Current of Vo12(mA) + Vin- Operation Range 6 Conversion Efficiency ∗1: Pulse noise is not included. Sample Application Circuit 12 C4 7 5 GND 4 3 2 1 External Component Settings This is the built-in FET of drain terminal. The primary coil minus side of the external transformer, and the snubber circuit for noise reduction are connected to this. Load Regulation Output Voltage Vo(V) Load regulation Output ripple voltage Power conversion efficiency1 Power conversion efficiency2 Conditions Io=800mA Refer to derating curve Vi=240V to 390VDC Io=800mA Io=50mA to 800mA ∗1 Conversion Efficiency η (%) Parameter Output voltage Output current Output Power (W) (Unless otherwise noted, Vi=311V, rated load Ta=25°C) 18.0 16.0 14.0 12.0 10.0 8.0 6.0 4.0 2.0 0.0 0 200 400 600 800 Output Current(mA) C1, C4: Capacitor for output voltage smoothing C2: For noise terminal voltage reduction C3: Capacitor for input voltage smoothing D1, D3: Rectifier diode D2: Rectifier diode R1: Resistor R2: Resistor T1: Switching transformer 470µF/35V Low impedance for power supply Rated ripple current 1.4Arms or higher ESR 35mΩ or below 2200pF/1kV 33µF/450V General purpose one 90V/6A 1kV/1A 100kΩ ±5% 3W Limiting element voltage 300V or higher 750kΩ ±5% 0.25W Limiting element voltage 600V or higher Custom one 1000 1200 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1