Model 72950 SMA PLUG STRAIGHT CRIMP, REVERSE POLARITY, RG174, 188, 316 Model 72950 SMA PLUG STRAIGHT CRIMP, REVERSE POLARITY, RG174, 188, 316 High bandwidth, small size, and durability for confident connections Features • DC – 4 GHz bandwidth. • Meets MIL-C-39012, IEC 169-15, CECC 22110. • Small size and durability for mobile communications. • Precision machined and gold-plated for low loss. Materials • • • • • Body is machined brass with gold plating. Center Contacts - Plug is gold plated brass and Jack is gold plated Beryllium copper. Insulators are high quality PTFE. Crimp Ferrules are copper with gold or nickel plating. Gaskets are silicone rubber. Specifications Impedance 50 Ω Frequency Range DC – 4 GHz Working Voltage < 375 Vpeak Dielectric Withstanding Voltage 1,000 Vrms VSWR 1.35 max. Center/Outer Contact Resistance 0.003/0.002 Ω max Insulation resistance > 5000 MΩ Number of Insertions 500 cycles minimum Temperature Range -65˚ C to 165˚ C, -85˚ F to 329˚ F Ordering Information Model: 72950 Description: SMA PLUG STRAIGHT CRIMP, REVERSE POLARITY, RG174, 188, 316 USA: Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (.51 mm), .xxx = ± .005” (.127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. D2003384 REV 001 Copyright © 2007 11/09/2007 Page 1 of 2 Model 72950 SMA PLUG STRAIGHT CRIMP, REVERSE POLARITY, RG174, 188, 316 Cable Types and Crimp Die Information Connector Model # 72950 Cable Groups RG174, 188, 316 Crimp Die Cavity Size for Outer Ferrule .128 (3.3) Cable Assembly Instructions USA: Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (.51 mm), .xxx = ± .005” (.127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. D2003384 REV 001 Copyright © 2007 11/09/2007 Page 2 of 2