UNISONIC TECHNOLOGIES CO., LTD P4596

UNISONIC TECHNOLOGIES CO., LTD
P4596
Preliminary
LINEAR INTEGRATED CIRCUIT
PWM CONTROL 3A
STEP-DOWN CONVERTER

DESCRIPTION
The UTC P4596 consists of 3A step-down switching regulator
with PWM control which includes a reference voltage source,
oscillation circuit, error amplifier, internal PMOS and etc.
The UTC P4596 can provide low-ripple power, high efficiency,
and excellent transient characteristics and an enable function, an
over current protect function and a short circuit protect function
are built inside, And the PWM control circuit can vary the duty
ratio linearly from 100 down to 0%. This converter also includes
an error amplifier circuit as well as a soft-start circuit that prevents
overshoot at startup. These ICs can work as step-down switching
regulators with the addition of an internal P-channel Power MOS,
a coil and a diode connected externally. They provide such
outstanding features: low current consumption. It is also suitable
for the operation via an AC adapter because this converter can
accommodate an input voltage up to 40V.

HSOP-8
FEATURES
* Input voltage:8V~40V
* Duty ratio:0%~100% PWM control
* Enable with Soft-Start function
* Oscillation frequency can be set by outside resistance
* Current Limit, SCP and OTP

ORDERING INFORMATION
Ordering Number
P4596G-SH2-R
Package
HSOP-8
Packing
Tape Reel
P4596G-SH2-R

(1)Packing Type
(1) R: Tape Reel
(2)Package Type
(2) SH2: HSOP-8
(3)Green Package
(3) G: Halogen Free and Lead Free
MARKING
www.unisonic.com.tw
Copyright © 2015 Unisonic Technologies Co., Ltd
1 of 4
QW-R103-064.b
P4596
Preliminary

PIN CONFIGURATION

PIN DESCRIPTION
PIN NO.
1
2
3
4
5
6
7
8

PIN NAME
EN/SS
VSS
VGATE
VCC
SW
FB
COMP
OSC
LINEAR INTEGRATED CIRCUIT
DESCRIPTION
Enable and Soft-start pin
Ground
Driver GATE clamping pin.
IC power supply pin
Switch pin.
Feedback voltage
Compensation pin
Frequency Set Pin.
BLOCK DIAGRAM
EN/SS
VCC
BIAS
2.5V
1.23V
REFERENCE REGULATOR
START-UP
OCP
Oscillator
0.815 V
FB
+
AMP
-
COMP.
+
COMP.
-
PWM
VGATE
VSS
OTP
COMP
OSC
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
SW
2 of 4
QW-R103-064.b
P4596

Preliminary
LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATING (TA=25°C)
PARAMETER
SYMBOL
RATINGS
UNIT
VCC Pin Voltage
VCC
VSS-0.3~VSS+45
V
Feedback Pin Voltage
VFB
VSS-0.3~6
V
EN/SS Pin Voltage
VEN/SS
VSS-0.3~6
V
OSC Pin Voltage
VOSC
VSS-0.3~3
V
COMP Pin Voltage
VCOMP
VSS-0.3~6
V
VGATE Pin Voltage
VGATE
VSS-0.3~VCC
V
Switch Pin Voltage
VSW
VSS-0.3~VCC+0.3
V
Power Dissipation
PD
Internally limited
mW
Operating Supply Voltage
VOP
8~40
V
Junction Temperature
TJ
-40~+125
°C
Storage Temperature
TSTG
-65~+150
°C
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.

ELECTRICAL CHARACTERISTICS (VCC=12V, TA=25°C, unless otherwise specified)
PARAMETER
Feedback Voltage
Quiescent Current
Feedback Bias Current
Shutdown Supply Current
Current Limit
Adjustable Frequency Range
Short Frequency
EN/SS Pin Shutdown Logic Input
Threshold Voltage
EN/SS Pull High Current
Internal MOSFET RDSON
SYMBOL
VFB
ICCQ
IFB
ISD
ICL
FOSC
FOSC1
VCC=10V~30V
MIN
TYP
IEN/SS
RDSON
VEN/SS=0V
VCC=12V, VFB=0V
MAX
UNIT
0.800 0.815 0.830
V
3
0.1
56
300
50
380
55
mA
μA
μA
A
KHz
KHz
0.8
V
180
μA
mΩ
10
3.5
50
45
VENL
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
TEST CONDITIONS
VCC=10V~30V, IOUT=0~2A
TJ=-20°C~125°C
VFB=1V
IOUT=0.1A
VEN/SS=0V
8
80
6
3 of 4
QW-R103-064.b
P4596

Preliminary
LINEAR INTEGRATED CIRCUIT
TYPICAL APPLICATION CIRCUIT
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 4
QW-R103-064.b