AZ764H 16 AMP HIGH TEMPERATURE MINIATURE POWER RELAY FEATURES • • • • • • • • Ambient temperature up to 105°C (221°F) Sensitive coil Dielectric strength 5000 Vrms Low height: 15.7 mm 16 Amp switching Isolation spacing greater than 10 mm Proof tracking index (PTI/CTI) 250 Reinforced insulation, EN 60730-1 (VDE 0631, part 1) EN 60335-1 (VDE 0700, part 1) • UL, CUR file E43203 • VDE certificate 40012572 GENERAL DATA CONTACTS Arrangement SPST (1 Form A) Ratings Resistive load: Max. switched power: 480 W or 4000 VA Max. switched current: 16 A Max. switched voltage: 300 VDC* or 400 VAC * Note: Rated Load UL, CUR VDE If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. 10 A at 250 VAC, General use [1][2] 16 A at 250 VAC, 100k cycles, 105°C [1] * 16 A at 250 VAC, 10k cycles, 105°C [2] 10 A at 250 VAC, 150k cycles, 105°C [1][2] * approved with open vent hole only Material Silver nickel [1], silver tin oxide [2] Resistance < 100 miliohms initially COIL Power Life Expectancy Mechanical Electrical (ohmic load at 105°C / 221°F) Minimum operations 3 x 107 1.7 x 105 at 10 A 230 VAC res. 2.8 x 105 at 8 A 230 VAC res. 3.2 x 105 at 6 A 230 VAC res. Operate Time (typical) 7 ms at nominal coil voltage Release Time (typical) 3 ms at nominal coil voltage (with no coil suppression) Dielectric Strength 5000 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts Insulation Resistance 105 megohms min. at 20°C 500 VDC 50% RH Insulation (according to DIN VDE 0110, IEC 60664-1) C250 Overvoltage category: III Pollution degree: 3 Nominal voltage: 250 VAC Dropout DC coils Greater than 10% of nominal coil voltage Ambient Temperature Operating At nominal coil voltage -40°C (-40°F) to 105°C (221°F) Vibration 20 g at 30…500 Hz Shock 30 g At Pickup Voltage (typical) 140 mW (DC coil) Enclosure P.B.T. polyester, UL-94 : V0 Max. Continuous Dissipation 2.2 W at 20°C (68°F) ambient Terminals Tinned copper alloy, P. C. Temperature Rise 16°C (29°F) at nominal coil voltage Max. Solder Temp. 270°C (518°F) 155°C (311°F) Class F Max. Solder Time 5 seconds Max. Solvent Temp. 80°C (176°F) Max. Immersion Time 30 seconds Weight 14 grams Packing unit in pcs 20 per carton tube / 1000 per carton box Max. Temperature NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. ZETTLER electronics GmbH Junkersstr. 3, D-82178 Puchheim, Germany phone: +49 89 800 97-0 [email protected] fax: +49 89 800 97-200 www.ZETTLERelectronics.com This product specification to be used only together with the application notes which can be downloaded from http://www.ZETTLERelectronics.com/pdfs/relais/ApplicationNotes.pdf 2013-02-26 AZ764H RELAY ORDERING DATA COIL SPECIFICATIONS - DC COIL Nominal Coil VDC Must Operate VDC ORDER NUMBER Max. Continuous VDC Coil Resistance Ohm ±10% 5 3.75 15.0 102 AZ764H–1AE–5DS 6 4.5 18.0 144 AZ764H–1AE–6DS 9 6.75 27.0 330 AZ764H–1AE–9DS 10 7.5 30.0 400 AZ764H–1AE–10DS 12 9.0 36.0 580 AZ764H–1AE–12DS 18 13.5 54.0 1,300 AZ764H–1AE–18DS 24 18.0 72.0 2,300 AZ764H–1AE–24DS 48 36.0 144.0 9,340 AZ764H–1AE–48DS * “1AE” denote silver tin oxide contacts. Substitute “1A” in place of “1AE” for silver nickel contacts. MECHANICAL DATA PC BOARD LAYOUT 1.142 [29.0] 0.500 Max. [12.7] Max. .794 [20.16] .197 [5.0] .098 [2.5] .295 [7.5] .618 Max. [15.7] .098 [2.5] 6 x ø .050 [ø 1.3] Viewed toward terminals .295 [7.5] .154 [3.9] 4 x .020 [0.5] WIRING DIAGRAM 2 x ø .024 [ø 0.6] 4 5 2 .295 [7.5] 4 x .035 [0.9] .197 [5.0] .794 [20.16] .098 [2.5] 8 7 1 Viewed toward terminals Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" DC - Coil operating range Max. DC resistive load breaking capacity 50 3.0 DC current [A] UB / U N 2.6 2.2 1.8 16 10 5 2 1.4 1 1.0 0,5 0.6 0 20 40 60 80 100 120 Ambient temperature [°C] 1 - no load on contacts, cold coil 2 - no load on contacts 3 - contact load 10A 0,1 10 20 30 40 50 100 200 300 DC voltage [V] ZETTLER electronics GmbH Junkersstr. 3, D-82178 Puchheim, Germany phone: +49 89 800 97-0 [email protected] fax: +49 89 800 97-200 www.ZETTLERelectronics.com This product specification to be used only together with the application notes which can be downloaded from http://www.ZETTLERelectronics.com/pdfs/relais/ApplicationNotes.pdf 2013-02-26