AZ696 10 AMP SUBMINIATURE POWER RELAY FEATURES • • • • • • • High sensitivity, 110 mW pickup Dielectric strength 4000 Vrms Isolation spacing greater than 8 mm Proof tracking index (PTI/CTI) 250 10 Amp switching capability Epoxy sealed version available Reinforced insulation, EN 60730-1 (VDE 0631, part 1) EN 60335-1 (VDE 0700, part 1) • UL, CUR file E43203 • VDE file 40012571 GENERAL DATA CONTACTS Arrangement SPDT (1 Form C) SPST (1 Form A and 1 Form B) Ratings Resistive load: Max. switched power: 240 W or 2500 VA Max. switched current: 10 A Max. switched voltage: 240 VDC* or 440 VAC Life Expectancy Mechanical Electrical Minimum operations 1 x 107 1 x 105 at 8 A 250 VAC Res. Operate Time (typical) 10 ms at nominal coil voltage Release Time (typical) 5 ms at nominal coil voltage (with no coil suppression) * Note: If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. Rated Load UL, CUR VDE 10 A at 30 VDC resistive 10 A at 250 VAC general use 1/4 HP 120 VAC 1/2 HP 250 VAC B 300 pilot duty 8 A at 250 VAC resistive, 100k cycles [1] 10 A at 250 VAC resistive, 50k cycles [2] Material Silver cadmium oxide [1] or silver tin oxide [2] Resistance < 30 milliohms initially COIL Power Dielectric Strength 4000 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts Insulation Resistance 1000 megohms min. at 20°C, 500 VDC, 50% RH Insulation (according to DIN VDE 0110, IEC 60664-1) C250 Overvoltage category: III Pollution degree: 3 Nominal voltage: 250 VAC Dropout Greater than 10% of nominal coil voltage Ambient Temperature Operating Storage At nominal coil voltage -40°C (-40°F) to 85°C (185°F) -40°C (-40°F) to 105°C (221°F) Vibration 0.062" (1.5 mm) DA at 10–55 Hz Shock 20 g Enclosure P.B.T. polyester, UL94 V-0 Terminals Tinned copper alloy, P.C. At Pickup Voltage (typical) 110 mW 140 mW (48 VDC coil) Max. Solder Temp. 270°C (518°F) Max. Continuous Dissipation 1.5 W at 20°C (68°F) ambient Max. Solder Time 5 seconds Temperature Rise 20°C (36°F) at nominal coil voltage Max. Solvent Temp. 80°C (176°F) Max. 110°C (230°F) Max. Immersion Time 30 seconds Weight 14 grams Packing unit in pcs 50 per plastic tray / 1500 per carton box Temperature NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. 4. It’s recommended to remove vent nipple on sealed versions to expand life expectancy when switching higher loads. ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2005-08-04 AZ696 RELAY ORDERING DATA COIL SPECIFICATIONS Nominal Coil VDC 5 ORDER NUMBER* Must Operate VDC 3.5 Max. Continuous VDC 12.0 Coil Resistance Ohm ± 10% 110 1 Form A (SPST-NO) AZ696–1A–5D 1 Form C (SPDT) AZ696–1C–5D 6 4.2 14.5 160 AZ696–1A–6D AZ696–1C–6D 9 6.3 22.0 360 AZ696–1A–9D AZ696–1C–9D 12 8.4 29.5 660 AZ696–1A–12D AZ696–1C–12D 18 12.6 44.0 1,500 AZ696–1A–18D AZ696–1C–18D 24 16.8 54.0 2,200 AZ696–1A–24D AZ696–1C–24D 48 33.6 102.0 8,000 AZ696–1A–48D AZ696–1C–48D * Substitute “1B” in place of “1A” for 1 Form B contact. Add suffix “E” to “1A” or “1B” or “1C” for silver tin oxide contacts. Add suffix “E” at the end of order number for sealed version. MECHANICAL DATA Coil Temperature Rise 1 FORM C 1 FORM A and 1 FORM B 100 90 80 1.10 (28) .394 (10) .394 (10) .618 (15.7) .618 (15.7) FORM C .638 (16.2) .638 (16.2) .138 (3.5) .138 (3.5) .024 x .035 (0.6 x 0.9) Coil Temperature Rise °C 1.18 (30) .024 x .035 (0.6 x 0.9) .024 x .039 (0.6 x 1) .024 x .039 (0.6 x 1) 70 10 A 60 50 0A 40 30 20 10 0 60 80 100 120 140 160 180 200 220 Percent of Nominal Coil Voltage at 20°C WIRING DIAGRAMS PC BOARD LAYOUT 1 FORM C 1 2 x ø .051 (ø 1.3) 1 FORM C Maximum Switching Capacity 4 10.0 .299 (7.6.) .748 (19.) .122 (3.1) 3 x ø .059 (ø 1.5) .126 (3.2) .126 (3.2) 2 3 9.0 8.0 7.0 6.0 5.0 5 DC Resistive Load 4.0 1 FORM A 1 3.0 3 AC Resistive Load 1 FORM A and 1 FORM B 2 x ø .051 (ø 1.3) 2 4 1 1.0 .9 .8 .7 .6 .5 .4 1 FORM B .299 (7.6.) CURRENT 2.0 .3 3 Viewed toward terminals Viewed toward terminals 1000 400 500 600 700 800 900 300 200 50 60 70 80 90 100 4 40 .1 2 30 .197 (5) 20 .122 (3.1) 10 .2 2 x ø .059 (ø 1.5) .748 (19) VOLTAGE Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2005-08-04