AZ764H 16 AMP HIGH TEMPERATURE MINIATURE POWER RELAY FEATURES • • • • • • • • Ambient Temperature up to 105°C (221°F) Sensitive coil Dielectric strength 5000 Vrms Low height: 15.7 mm 16 Amp switching Isolation spacing greater than 10 mm Proof tracking index (PTI/CTI) 250 Reinforced insulation, EN 60730-1 (VDE 0631, part 1) EN 60335-1 (VDE 0700, part 1) • UL, CUR file E43203 • VDE file 40012572 CONTACTS GENERAL DATA Arrangement SPST (1 Form A) Ratings Resistive load: Max. switched power: 480 W or 4000 VA Max. switched current: 16 A Max. switched voltage: 300 VDC* or 400 VAC * Note: If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. Rated Load UL, CUR Life Expectancy Mechanical Electrical (ohmic load at 105°C / 221°F) Minimum operations 3 x 107 1.7 x 105 at 10 A 230 VAC res. 2.8 x 105 at 8 A 230 VAC res. 3.2 x 105 at 6 A 230 VAC res. Operate Time (typical) 7 ms at nominal coil voltage Release Time (typical) 3 ms at nominal coil voltage (with no coil suppression) 10 A at 250 VAC general use Dielectric Strength 5000 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts 10 A at 250 VAC resistive, 105 °C, 150k cycles 16 A at 250 VAC resistive, 105 °C, 10k cycles Insulation Resistance 105 megohms min. at 20°C 500 VDC 50% RH Material Silver silver tin oxide Resistance < 100 milliohms initially Insulation (according to DIN VDE 0110, IEC 60664-1) C250 Overvoltage category: III Pollution degree: 3 Nominal voltage: 250 VAC Dropout DC coils Greater than 10% of nominal coil voltage Ambient Temperature Operating Storage At nominal coil voltage -40°C (-40°F) to 105°C (221°F) -40°C (-40°F) to 105°C (221°F) Vibration 20 g at 30…500 Hz Shock 30 g Enclosure P.B.T. polyester, UL-94 ; V0 Terminals Tinned copper alloy, P. C. Max. Solder Temp. 270°C (518°F) Max. Solder Time 5 seconds Max. Solvent Temp. 80°C (176°F) Max. Immersion Time 30 seconds 2. Relay may pull in with less than “Must Operate” value. Weight 14 grams 3. Specifications subject to change without notice. Packing unit in pcs 20 per carton tube / 1000 per carton box VDE COIL Power At Pickup Voltage (typical) 140 mW (DC coil) Max. Continuous Dissipation 2.2 W at 20°C (68°F) ambient Temperature Rise 16°C (29°F) at nominal coil voltage Max. Temperature 155°C (311°F) NOTES 1. All values at 20°C (68°F). ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2005-08-04 AZ764H RELAY ORDERING DATA COIL SPECIFICATIONS - DC COIL Nominal Coil VDC Must Operate VDC ORDER NUMBER Max. Continuous VDC Coil Resistance Ohm ±10% 5 3.75 15.0 102 AZ764H–1AE–5DS 6 4.5 18.0 144 AZ764H–1AE–6DS 9 6.75 27.0 330 AZ764H–1AE–9DS 10 7.5 30.0 400 AZ764H–1AE–10DS 12 9.0 36.0 580 AZ764H–1AE–12DS 18 13.5 54.0 1,300 AZ764H–1AE–18DS 24 18.0 72.0 2,300 AZ764H–1AE–24DS 48 36.0 144.0 9,340 AZ764H–1AE–48DS MECHANICAL DATA PC BOARD LAYOUT 1.142 [29.0] 0.500 Max. [12.7] Max. .794 [20.16] .197 [5.0] .098 [2.5] .295 [7.5] .618 Max. [15.7] .098 [2.5] 6 x ø .050 [ø 1.3] Viewed toward terminals .295 [7.5] .154 [3.9] 4 x .020 [0.5] WIRING DIAGRAM 2 x ø .024 [ø 0.6] 4 5 2 .295 [7.5] 4 x .035 [0.9] .794 [20.16] .197 [5.0] .098 [2.5] 8 7 1 Viewed toward terminals Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" DC - Coil operating range Max. DC resistive load breaking capacity 50 3.0 DC current [A] UB / U N 2.6 2.2 1.8 16 10 5 2 1.4 1 1.0 0,5 0.6 0 20 40 60 80 100 120 Ambient temperature [°C] 1 - no load on contacts, cold coil 2 - no load on contacts 3 - contact load 10A ZETTLER 0,1 10 20 30 40 50 100 200 300 DC voltage [V] electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2005-08-04