SP6003A Synchronous Rectifier Driver DESCRIPTION The fundamental of SP6003A synchronous rectifier (SR) driver IC is based on our U.S. patented methods that utilize the principle of “prediction” logic circuit. The IC deliberates previous cycle timing to control the SR in present cycle by “predictive” algorithm that makes adjustments to the turn-off time, in order to achieve maximum efficiency and avoid cross-conduction at the same time. It also maintains the MOSFET’s body diode conduction at minimum level. The SP6003A is capable to adapt in almost all existing flyback converters with few adjustments considered necessary. APPLICATIONS • Servers & workstations FEATURES • Offers efficiency improvement over Schottky Diode (depends on drive configuration of the SR). PIN CONFIGURATION (SOP-8) • Drives all logic level Power MOSFET. • Prediction gate timing control. • Minimum MOSFET body diode conduction. • Operating frequency up to 650 KHz. • Synchronize to transformer voltage waveform. 2012/08/29 Ver.5 secondary • Storage area network power supplies • Telecommunication converters • Embedded systems • Industrial & commercial systems using high current processors PART MARKING Page 1 SP6003A Synchronous Rectifier Driver TYPICAL APPLCATION CIRCUIT PIN DESCRIPTION Pin Symbol 1 Timing 2 Pred 3 Rapid-Adj Capacitor connection to adjust fast pulse width reduction response. 4 5 6 7 8 Cramp GND MOSG-C Vdd SYNC Ramp capacitor adjustment to extend MOSFET’s gate timing. Ground connection. Catch MOSFET gate drive. DC supply voltage. Synchronized signal from transformer’s output. 2012/08/29 Ver.5 Description Discontinuous current filter timing adjustment resistor connection. Capacitor to store previous cycle timing for Catch MOSFET Page 2 SP6003A Synchronous Rectifier Driver BLOCK DIAGRAM ORDERING INFORMATION Part Number SP6003AS8RG SP6003AS8TG SP6003AS8RGB SP6003AS8TGB ※ SP6003AS8RG : 7” Tape Reel ; Pb – Free Package Part Marking SOP-8 SOP-8 SOP-8 SOP-8 SP6003AI SP6003AI SP6003AI SP6003AI ※ SP6003AS8TG : Tube ; Pb – Free ※ SP6003AS8RGB : 7” Tape Reel ; Pb – Free ; Halogen -Free ※ SP6003AS8TGB : Tube ; Pb – Free ; Halogen –Free ABSOULTE MAXIMUM RATINGS (TA=25℃, unless otherwise specified.) The following ratings designate persistent limits beyond which damage to the device may occur. Symbol Vdd SYNC IOUT PD TJ TSTG TLEAD Parameter DC Supply Voltage SYNC Voltage Peak Source Current (Pulsed) Peak Sink Current (Pulsed) Power Dissipation @ TA=85℃ (*) Operating Junction Temperature Range Storage Temperature Range Lead Soldering Temperature for 5 sec. 2012/08/29 Ver.5 Value 7 7.5 1 1.5 0.25 -40 to 150 -40 to 150 260 Unit V V A A W ℃ ℃ ℃ Page 3 SP6003A Synchronous Rectifier Driver THERMAL RESISTANCE Symbol RӨJC Parameter Thermal Resistance Junction – Case (*) Value 45 Unit ℃/W (*) The power dissipation and thermal resistance are evaluated under copper board mounted with free air conditions. ELECTRICAL CHARACTERISTICS (TA=25℃, Vdd=5V, VSYNC=5V, Freq. =300 KHz, Duty Cycle=50%, unless otherwise specified.) Symbol Parameter SUPPLY INPUT IDD Supply current Vonth Vdd turn on threshold Voffth Vdd turn off threshold SYNC REFERENCE (SYNC) Vshth SYNC high threshold Vslth SYNC low threshold MOSFET GATE DRIVER (MOSG-C) Voh Output high voltage Vol Output low voltage Td Propagation delay Tr Rise time Tf Fall time Conditions No load Min. Typ. Max. Unit 4 5.5 5.0 4.1 8 7.0 mA V V 3.8 3.9 Io = -200mA Io = 200mA No load Load = 1nF (*) Load = 1nF (*) 4.8 0.0 15 24 20 5.0 0.9 1.2 V V 4.9 0.1 20 28 23 5.0 0.2 25 36 30 V V ns ns ns (*) Tr & Tf are measured among 10% and 90% of starting and final voltage. 2012/08/29 Ver.5 Page 4 SP6003A Synchronous Rectifier Driver PERFORMANCE CHARACTERISTICS (TA=25℃, unless otherwise specified.) Figure 4: Supply Current vs Load Capacitor Figure 1: Supply Current vs Supply Voltage 20 18 16 14 12 ID D 10 (m A) 8 6 4 2 0 10 9 8 7 6 ID D 5 (m A) 4 3 2 1 0 3.3 3.5 3.7 4 4.2 4.4 4.6 4.9 5 5.3 5.5 5.7 6.1 220 330 470 680 1000 1560 2200 2530 2880 V D D (V) CLoa d (pF) Figure 2: Output Rise Tim e vs Load Capacitor Figure 5: Supply Current vs Freq. @ No Load 70 7 60 6 50 5 Tim e 40 (ns) 30 ID D 4 (m A) 3 20 2 10 1 0 0 220 330 470 680 1000 CLo ad (pF) 1330 1680 20 50 81 154 184 256 327 380 425 484 554 Frequency (kHz) Figure 3: Output Fall Tim e vs Load Capacitor Figure 6: Supply Current vs Freq. @ Load=1nF 20 70 18 60 16 50 14 Tim e 40 (ns) 30 12 ID D 10 (m A) 8 20 6 4 10 2 0 0 220 330 470 680 1000 CLo a d (pF) 1330 1680 30 50 70 93 119 128 149 170 176 Frequency (kHz) *Fig. 2-4: Frequency = 85 kHz. 2012/08/29 Ver.5 Page 5 SP6003A Synchronous Rectifier Driver SOP- 8 PACKAGE OUTLINE 2012/08/29 Ver.5 Page 6 SP6003A Synchronous Rectifier Driver Information provided is alleged to be exact and consistent. SYNC Power Corporation presumes no responsibility for the penalties of use of such information or for any violation of patents or other rights of third parties, which may result from its use. No license is granted by allegation or otherwise under any patent or patent rights of SYNC Power Corporation. Conditions mentioned in this publication are subject to change without notice. This publication surpasses and replaces all information previously supplied. SYNC Power Corporation products are not authorized for use as critical components in life support devices or systems without express written approval of SYNC Power Corporation. ©The SYNC Power logo is a registered trademark of SYNC Power Corporation ©2004 SYNC Power Corporation – Printed in Taiwan – All Rights Reserved SYNC Power Corporation 7F-2, No.3-1, Park Street NanKang District (NKSP), Taipei, Taiwan, 115, R.O.C Phone: 886-2-2655-8178 Fax: 886-2-2655-8468 http://www.syncpower.com 2012/08/29 Ver.5 Page 7