saftbatteries.com

Primary lithium battery
LS 14250W
3.6 V Primary lithium-thionyl chloride (Li-SOCl2)
High energy density
1
⁄2 AA-size bobbin cell
For demanding environments up to + 95ºC
For applications requesting superior
voltage response and operating life
in Widely fluctuating temperature
environments up to + 95ºC.
Benefits
l
High voltage response, stable
during most of the lifetime of the
application
l
Superior voltage readings after
exposure at elevated temperature
l
Voltage readings during pulsing
moderately affected by T fluctuations
l
Low self-discharge rate (less than
1 % per year of storage at + 20ºC)
l
Easy integration into compact
systems
l
Superior resistance to atmospheric
corrosion
Key features
l
Stainless steel container and end
caps (low magnetic signature)
lHermetic glass-to-metal sealing
lNon-flammable electrolyte
lCompliant with IEC 60086-4 safety standard and IEC 60079-11
intrinsic safety standard
(class T4 assignment)
lUnderwriters Laboratories (UL) Component Recognition
lNon-restricted for transport/
Non-assigned to Class 9
according to the UN
Recommendations on the
transport of dangerous goods Model Regulations
lManufactured in France, China
Main applications
lElectronic toll collection
lUtility metering
lAutomatic meter reading
lAlarms and security devices
lTracking systems
lAutomotive electronics
lProfessional electronics
February 2010
½ R6 – ½ AA
Cell size references
Electrical characteristics
(typical values relative to cells stored for one year or less at + 30ºC max.)
Nominal capacity
(at 1 mA + 20ºC 2.0 V cut-off. The capacity restored by the cell varies
according to current drain, temperature and cut-off)
Open circuit voltage (at + 20ºC)
Nominal voltage
1.20 Ah
3.67 V
(at 0.1 mA + 20ºC)
3.6 V
Nominal energy
4.32 Wh
Pulse capability : Typically up to 100 mA
(100 mA/0.1 second pulses, drained every 2 mn at + 20ºC from undischarged cells with
10 µA base current, yield voltage readings above 3.0 V. The readings may vary according
to the pulse characteristics, the temperature, and the cell’s previous history. Fitting the cell
with a capacitor may be recommended in severe conditions. Consult Saft)
Maximum recommended continuous current
(Higher currents are possible, consult Saft)
Storage 20 mA
(recommended)
(for more severe conditions, consult Saft)
+ 30ºC (+ 86ºF) max
Operating temperature range
(Operation above ambient T may lead to reduced capacity and lower voltage readings at the beginning of pulses. Consult Saft)
- 60ºC/+ 95ºC
(- 76ºF/+ 203ºF)
Physical characteristics
Diameter (max)
14.55 mm (0.57 in)
Height (max)
25.15 mm (0.99 in)
Typical weight
8.9 g (0.3 oz)
Li metal content
approx. 0.3 g
Available termination suffix
CN, CNR
2 PF, 3 PF, 3 PF RP, 4 PF
CNA (AX)
FL
radial tabs
radial pins
axial leads
flying leads ...etc.
LS 14250W
Cell voltage (V)
Voltage plateau versus Current and Temperature (at mid-discharge)
Ø 4.2 min
5.5 max
(flat area)
Current (mA)
1.35 ± 0.3
0.4 ± 0.1 Ø 14.44
± 0.11
Typical discharge profiles at + 20ºC
Ø 7.5
± 0.1
(flat area)
Dimensions in mm.
Cell voltage (V)
24.65 ± 0.5
Time (hours)
Storage
Warning
l
Fire,
explosion and burn hazard.
not recharge, short circuit,
crush, disassemble, heat above
100ºC (212ºF), incinerate,
or expose contents to water.
l
Do not solder directly to the cell
(use tabbed cell versions instead).
l
Do
Saft
Specialty Battery Group
1.35 ± 0.2
12, rue Sadi Carnot
93170 Bagnolet - France
Tel.: +33 (0)1 49 93 19 18
Fax: +33 (0)1 49 93 19 69
www.saftbatteries.com
Capacity (mAh)
storage area should be
clean, cool (preferably not
exceeding + 30ºC), dry and
ventilated.
Restored Capacity versus Current and Temperature (2.0 V cut-off)
l
The
Current (mA)
Doc. No 31087-2-0210
Information in this document is subject to change without notice
and becomes contractual only after written confirmation by Saft.
For more details on primary lithium technologies please refer to
Primary Lithium Batteries Selector Guide Doc No 31048-2.
Published by the Communications Department.
Photo credit: Saft
Société anonyme au capital de 31 944 000€
RCS Bobigny B 383 703 873
Produced by Arthur Associates Limited.