The ZSSC5101 xMR Sensor Signal Conditioner offers features well suited to consumer applications, such as non-contacting potentiometers: Can be used with optimized MR-sensing bridges for rotational or linear position measurement CMOS integrated circuit for converting sine and cosine signals obtained from magnetoresistive bridge sensors into a ratiometric analog voltage with a user-programmable range of travel and clamping levels – optimized for angular or linear position sensing Accepts anisotropic, giant, and tunnel magnetoresistive bridge sensors (AMR, GMR and TMR); allows large air gaps between sensors and magnets and can be used with low-cost ferrite magnets Optimized for harsh environments with extended temperature range (-40 C to +160 C for die) and special protection circuitry with excellent electromagnetic compatibility Offset calibration of the bridge input signals Ratiometric analog output with up to 4608 analog steps and step sizes as small as 0.022° CRC, error detection, and error correction on EEPROM data; broken-wire detection; loss of magnet indication with programmable threshold level; and power supply monitoring Programmable linear transfer characteristic: zero position, angular range, upper and lower clamping levels, rising or falling slope High accuracy: ± 0.15° integral nonlinearity (INL) after calibration No mechanical alignment required Supply voltage: 4.5V to 5.5V Smallest footprint available: SSOP14 For more information about consumer applications for the ZSSC5101 and other ZMDI products, view our Global Product Brochure by clicking here Typical ZMDI Consumer Applications In consumer electronics, ZMDI reduces energy consumption by enabling precise sensor measurements through ZMDI’s complete line of low-power sensor signal conditioner ICs. Smart phone Mobile navigation Barometric altitude measurement devices Home appliances Office equipment Contact ZMDI to inquire about consumer applications specific to the ZSSC5101 by clicking HERE.