TAI-SAW TECHNOLOGY CO., LTD. 14.1x9.1 20MHz OCXO MODEL NO.: TP0026A REV. NO.: 1.0 Revise: Rev. Rev. Page Rev. Account Date 1 N/A Initial release 11/15/11’ N/A TAI-SAW TECHNOLOGY CO., LTD. Ref. No. Reviser Ginger Huang TST DCC Release document 2 TAI-SAW TECHNOLOGY CO., LTD. No. 3, Industrial 2nd Rd., Ping-Chen Industrial District, Taoyuan, 324, Taiwan, R.O.C. TEL: 886-3-4690038 FAX: 886-3-4697532 E-mail: [email protected] Web: www.taisaw.com 14.1x9.1 20MHz OCXO MODEL NO.: TP0026A REV. NO: 1.0 Characteristics Values Unit Nominal Frequency 20 MHz Temperature Range Characteristics Operating G1 Storage Power - Consumption Characteristics Power Supply Max values at steady state Max values during Warm-up Output Signal Characteristics Level Frequency Stability Characteristics VS Temperature Range G1 VS Power Supply variation VS Load variation Tol ±500 ppb max @ 25°C ±2°C, warmup 30 ±5 minutes within 90 days after shipment Min. -20 -40 Nom. Max. 70 85 Unit °C °C Note Min. 3.14 Nom. 3.3 Max. 3.47 400 900 Unit V mA mA Note Vcc ±5% 1.3W at 25°C 3W, heating time < 3 min Nom. Max. Unit Volt Volt ns % dBc pF Note Unit ±ppb ±ppb ±ppb Note Refer to freq at 25°C Vcc ±5% Static Load ±5% LVCMOS Min. VOH 2.4 VOL Rise/Fall time Duty cycle Non-harmonics Spur Load Note 0.4 6 55 -60 45 15 Min. Nom. Max. 50 10 10 Aging Characteristics Medium/Long Term Stability Warm Up Values 1 day 1 year 10years NA 2000 5000 2 mn 100 Phase Noise Characteristics Static Conditions Note Unit ±ppb ±ppb After continuous operating for 1 month at 25°C Refer to 1H power on @ 25°C Values 1 Hz Note 10 Hz 100Hz 1 KHz -85 -110 -130 Unit 10 100KHz KHz -145 -145 dBc/Hz TAI-SAW TECHNOLOGY CO., LTD. TST DCC Release document 3 Mechanical Conditions Characteristics Shocks (Non-operating) Sine Vibrations (Non-operating) Conditions MIL-STD-202, Method 213, Test Condition J (30 g, 11 ms half-sine) MIL-STD-202, Method 201 (0.06" Total p-p, 10 to 55 Hz) Package - Pin Out Package Ref. Maximum package height S1 6.85mm Pad 1: Pad 2: Pad 3: Pad 4: Pad 5: Pad 6: Pin Out drawing Unit: mm N/C or Vctrl N/C Ground output N/C Vcc Mechanical drawing Package Ref. S1 Top View Side View Bottom View Suggested Pad Layout 9.52 2,16 6,6 1,02 1,52 2,16 Top View Keep Out Area DNC: Do Not Connect Dimensional Tolerance: +/-0.005 (0.127mm) TAI-SAW TECHNOLOGY CO., LTD. TST DCC Release document 4