BlueCore® CSR8350 A08 BGA Features ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 2-mic CVC® A2DP Decoding on Chip Fully Qualified Single-chip Bluetooth® v4.1 System Production Information CSR8350A08 Issue 1 General Description Applications CSR8350 BGA is a product from CSR's Connectivity Centre. It is a single-chip radio and baseband IC for Bluetooth 2.4GHz systems. Integrated peripherals reduce the number of external components required, including external codec, SMPS, LDOs, balun or program memory, ensuring minimum production costs. The SW architecture enables the CSR8350 BGA to run CVC Handsfree/Wired and A2DP decoders on chip to reduce the MIPS requirement on the host. Enhanced Kalimba DSP coprocessor with 80MIPS supports enhanced audio and DSP applications. Bluetooth enabled audio car system In-vehicle navigation PND An integrated audio codec supports 2 channels of ADC, 2 digital microphone inputs and stereo output, as well as a variety of audio standards. The on-chip MCU operates the Bluetooth stack up to the HCI. A host processor must provide all upper layers including the application and interfaces to the chip using a UART/USB physical layer. XTAL ■ ■ ■ SPI/ I2C ROM UART/USB RAM BT_RF 2.4GHz Radio + Balun Baseband Serial Flash / EEPROM I/O PIO MCU Audio In / Out Kalimba DSP Debug SPI Production Information © Cambridge Silicon Radio Limited 2015 Confidential Information - This material is subject to CSR's non-disclosure agreement Page 1 of 4 CS-317521-TOP1 www.csr.com CSR8350 BGA Technical Overview ■ High-end HCI Automotive Solution Bluetooth Smart Ready Bluetooth v4.1 specification compliant 80MHz RISC MCU and 80MIPS Kalimba DSP Extra DSP capabilities available as add-ons, downloadable from host (e.g. AAC, MP3 decoder) Internal ROM, serial flash memory and EEPROM interfaces Stereo/Dual-mono codec with 2 microphone inputs and stereo audio output Radio includes integrated balun CSR's latest 2-mic CVC ® Handsfree algorithm for narrowband and wideband in-car voice connections, including wind noise reduction Embedded SBC and aptX codec (decoder and encoder) for A2DP Embedded Wide band speech support for Handsfree profile Secure simple pairing, CSR's proximity pairing and CSR's proximity connection 2 x PCM/I²S digital audio interfaces Serial interfaces: UART, USB 2.0 (full-speed), I²C and SPI Integrated dual switch-mode regulators and linear regulators External crystal load capacitors not required for typical crystals 68‑ball VFBGA 5.5 x 5.5 x 1mm 0.5mm pitch Green (RoHS compliant and no antimony or halogenated flame retardants) Device Details Audio Interfaces Audio codec with 2 high-quality dedicated ADCs Microphone bias generator and up to 2 analogue microphone inputs ■ 2 digital microphone inputs (MEMS) ■ Enhanced side-tone gain control ■ Supported sample rates of 8, 11.025, 16, 22.05, 32, 44.1, 48 and 96kHz (DAC only) Physical Interfaces ■ High-speed UART (up to 4 Mbps) interface ■ USB 2.0 (full-speed) interface ■ 1-bit SPI flash memory interface ■ SPI interface for debug and programming ■ I²C interface for EEPROM ■ Up to 22 general purpose PIOs ■ 2 x PCM interface/I²S interface Integrated Power Control and Regulation ■ 2 high-efficiency switch-mode regulators with 1.8V and 1.35V outputs ■ 3.3V linear regulator for USB supply ■ Low-voltage linear regulator for internal digital circuits ■ Low-voltage linear regulator for internal analogue circuits ■ Power-on-reset detects low supply voltage ■ Power management includes digital shutdown and wake-up commands for ultra-low power modes Baseband and Software ■ Internal ROM ■ 56KB internal RAM, enables full-speed data transfer, mixed voice/data and full piconet support ■ Logic for forward error correction, header error control, access code correlation, CRC, demodulation, encryption bit stream generation, whitening and transmit pulse shaping ■ Transcoders for A-law, µ-law and linear voice from host and A-law, µ-law and CVSD voice over air ■ Support for IEEE 802.11 coexistence Auxiliary Features ■ Crystal oscillator with built-in digital trimming Package Option ■ 68‑ball VFBGA 5.5 x 5.5 x 1mm 0.5mm pitch ■ ■ Production Information © Cambridge Silicon Radio Limited 2015 Confidential Information - This material is subject to CSR's non-disclosure agreement Page 2 of 4 CS-317521-TOP1 www.csr.com CSR8350 BGA Technical Overview Bluetooth low energy ■ Dual-mode Bluetooth low energy radio ■ Support for Bluetooth BDR/EDR and low energy connections Bluetooth Radio ■ On-chip balun (50Ω impedance in TX and RX modes) ■ No trimming of external components required in production ■ Bluetooth v4.1 specification compliant Bluetooth Transmitter ■ 9dBm RF transmit power with level control from onchip 6-bit DAC ■ Class 1, Class 2 and Class 3 support without the need for an external power amplifier or TX/RX switch Bluetooth Receiver ■ BDR receiver sensitivity of -90dBm ■ EDR receiver sensitivity of -91dBm (Typical) for π/4 DQPSK and -82dBm (Typical) for 8DPSK ■ Integrated channel filters ■ Digital demodulator for improved sensitivity and cochannel rejection ■ Real-time digitised RSSI available to application ■ Fast AGC for enhanced dynamic range ■ Channel classification for AFH Bluetooth Synthesiser ■ Fully integrated synthesiser requires no external VCO, varactor diode, resonator or loop filter ■ Compatible with crystals 16MHz to 32MHz Kalimba DSP ■ Enhanced Kalimba DSP coprocessor, 80MIPS, 24‑bit fixed point core ■ 2 single-cycle MACs; 24 x 24-bit multiply and 56-bit accumulator ■ 32-bit instruction word, dual 24-bit data memory ■ 6K x 32-bit program RAM including 1K instruction cache for executing out of internal ROM ■ 16K x 24-bit + 16K x 24-bit 2-bank data RAM CSR8350 In-vehicle Infotainment Details CSR8350 HCI Control AVDTP Signalling over L2CAP Host CSR Synergy USB/ UART Upper Stack Profiles Kalimba DSP Option 1 AVCTP Signalling and Browsing over L2CAP Decoder Resampler From Air Shunt Stream AVDTP Streaming Audio over L2CAP Mandatory: SBC Ringtone Generator Option 2 SCO Send CVC Send Bluetooth Voice over (e)SCO NBS: CVSD WBS: mSBC Application Hands-free Unit (e)SCO Stream SCO Receive A2DP Sink SEP CVC Receive Option 3 CVC Receive CVC Send User Interface DUN over RFCOMM Audio OBEX over L2CAP / RFCOMM Key to CSR8350 configurations: • • • Buttons Source and Destination of Audio is Host Configurable Analogue Audio Digital Audio Option 1: From-Air Shunt Data Decoder Option 2: eSCO Stream CVC Functionality Option 3: Wired Mode CVC Functionality Figure : Example In-vehicle Infotainment Details Improved Audio Quality DSP Features ■ DSPManager to control and configure DSP CSR’s latest 2-mic CVC Handsfree audio enhancements capabilities for specific use cases for narrowband and wideband connections including: ■ ■ Default on-chip DSP capabilities: 2-mic far-end audio enhancements ■ ■ Near-end audio enhancements (noise suppression A2DP aptX decoder and encoder (requires and AEQ) license key) ■ ■ Wind noise reduction A2DP SBC decoder and encoder ■ ■ Packet loss concealment Sample rate conversion (resampler), to resample audio signals. Provides flexibility to ■ Bit error and packet loss concealment host when implementing A2DP or HFP ■ Automatic gain control ■ Configurable ringtone generator ■ Noise dependent volume control ■ 2-mic CVC for narrowband, wideband or ■ Frequency expansion for improved speech frequency expansion intelligibility ■ SCO encoder and decoder for narrowband and ■ mSBC codec support for wideband speech wideband ■ Mono and stereo passthrough capabilities to route audio from host to on-chip codec ■ CSR can provide extra DSP capabilities as add-ons downloadable from the host, e.g. AAC, aptX decoders, or customised user defined processing algorithms Production Information © Cambridge Silicon Radio Limited 2015 Confidential Information - This material is subject to CSR's non-disclosure agreement Page 3 of 4 CS-317521-TOP1 www.csr.com CSR8350 BGA Technical Overview HFP Signalling over RFCOMM 1 Ordering Information Package Device CSR8350 In-vehicle Infotainment Type Size Shipment Method VFBGA‑68‑ball (Pb free) 5.5 x 5.5 x 1mm 0.5mm pitch Tape and reel Order Number CSR8350A08‑ABBC‑R Note: CSR8350 BGA is a ROM-based device where the product code has the form CSR8350Axx. Axx is the specific ROM-variant, A08 is the ROM-variant for CSR8350 In-vehicle Infotainment. Minimum order quantity is 4kpcs taped and reeled. Document History Revision Date Change Reason Issue 1 10 MAR 15 Original publication of this document. Trademarks, Patents and Licences Unless otherwise stated, words and logos marked with ™ or ® are trademarks registered or owned by CSR plc or its affiliates. Bluetooth ® and the Bluetooth ® logos are trademarks owned by Bluetooth ® SIG, Inc. and licensed to CSR. Other products, services and names used in this document may have been trademarked by their respective owners. The publication of this information does not imply that any license is granted under any patent or other rights owned by CSR plc and/or its affiliates. CSR reserves the right to make technical changes to its products as part of its development programme. While every care has been taken to ensure the accuracy of the contents of this document, CSR cannot accept responsibility for any errors. Refer to www.csrsupport.com for compliance and conformance to standards information. Production Information © Cambridge Silicon Radio Limited 2015 Confidential Information - This material is subject to CSR's non-disclosure agreement Page 4 of 4 CS-317521-TOP1 www.csr.com CSR8350 BGA Technical Overview Supply chain: CSR's manufacturing policy is to multisource volume products. For further details, contact your local sales account manager or representative.