P-tec Corp. Tel:(866) 695 4162 2405 Commerce Circle Tel:(719) 589 3122 Alamosa CO 81101 Fax:(719) 589 3592 www.p-tec.net PC1602K-O Series (16x2) Character Display Absolute Maximum Ratings at TA = 25°C Features *16 Character, 2 Line *View Angle 12H or 6H *STN Fluid Yellow, Gray or Blue *Extended Temperature Range available *LED Backlight available *RoHS Compliant Item Symbol Min Max Unit Power Supply (Logic) Vdd -0.3 7.0 V Power Supply (LCD) Vlcd (Vdd-Vo) -13.5 0.3 V Vi -0.3 Vdd+0.3 V Operating Temperature (Standard) Topr 0 50 °C Storage Temperature (Standard) Tstg -10 60 °C Extended Operating Temperature Topr -20 70 °C Extended Storage Temperature Tstg -30 80 °C Input Voltage Electrical Characteristics at TA = 25°C, Vdd=5V+0.25V Item Symbol Min Typ Max Unit Power Supply (Logic) Vdd-Vss 4.5 5.0 5.5 V Idd 0.8 1.2 1.5 mA LCD Driving Voltage Vdd -Vo 4.7 5.0 5.7 V LCD Driving Current llcd - 0.2 0.4 mA Supply Current Interface Pin Connection No Symbol Function No Symbol Function 1 Vss Power Supply (GND) 9 DB2 Data Bus Line 2 2 Vdd Power Supply (+5V) 10 DB3 Data Bus Line 3 3 Vo Contrast Adjust 11 DB4 Data Bus Line 4 4 RS Instruction/Register Select 12 DB5 Data Bus Line 5 5 R/W Read/Write 13 DB6 Data Bus Line 6 6 E Enable Signal 14 DB7 Data Bus Line 7 7 DB0 Data Bus Line 0 15 A Power Supply for LED Backlight (+) 8 DB1 Data Bus Line 1 16 K Power Supply for LED Backlight (-) LED Backlight Specifications Forward Voltage Forward Current Power Dissipation Peak Wavelength 4.4V (Max) 120mA (Max) 490mW (Max) 570nm (Typ) Mechanical Specifications Item Overall Size Specifications 85.0W x 30.0H x 10.0T (BL14.0T) Viewing Area Character Size Character Pitch Dot Size 64.5W x 15.5H 2.95W x 5.55H 3.55 x 5.95 0.55W x 0.65H All dimensions are in mm. Tolerance is ± 0.3 Unless otherwise specified 03.13.15 JAS Rev1 P-tec Corp. Tel:(866) 695 4162 2405 Commerce Circle Tel:(719) 589 3122 Alamosa CO 81101 Fax:(719) 589 3592 www.p-tec.net PC1602K-O Series (16x2) Character Display LCD Block Diagram Dot Layout S6A0069 or Equivalent All dimensions are in mm. Tolerance is ± 0.3 Unless otherwise specified 03.13.15 JAS Rev1