Command™ Instructions

17604B
command.com
To Apply
1
2
3
BLACK
SIDE
4
4
5
RED
SIDE
1. Choose a location where strips are not over grout lines, if possible. CAUTION: Place caddy in accessible position for removal by ensuring tabs can stretch at least 15
INCHES (38 cm) upon removal. 2. CLEAN surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. SEPARATE strips. 3. Slide both
bases into place on back of caddy until they snap. Arrow at top of mounting base should be pointing down. 4. REMOVE RED liner. PRESS adhesive to caddy. Repeat with
second strip. REMOVE BLACK liners. 5. PRESS to surface for 10 seconds.
7
6
UP
8
9
1 HOUR
10
OR
24 HOURS
30
DOWN
SECONDS
6. IMPORTANT: For maximum holding strength slide caddy off. 7. And press base FIRMLY for 30 seconds. 8. Slide caddy ON until it snaps.
9. If mounting outside of shower or tub area, wait 1 hour before use. If mounting in a shower or tub area, especially on ceramic tile or glass, use shower at lease once
and wait 24 hours to allow adhesive to bond before applying caddy. 10. Insert hook at an angle in desired location on caddy. Rotate down and snap into place.
To Remove
1
UP
S
L
O
W
L
Y
3
2
STRAIGHT
DOWN
4
15"
38 cm
1. Slide caddy up to remove from mounting base. 2. NEVER pull strip towards you. 3. Hold base gently to prevent base from
snapping fingers. DO NOT press base against wall. 4. STRETCH STRAIGHT DOWN ALONG WALL AT LEAST
15 INCHES (38 cm) until base and strip release. Remove one strip at a time. Repeat with additional strips.
IMPORTANT: Failure to follow instructions carefully may cause damage!
SAVE INSTRUCTIONS for damage-free removal or visit command.com
For questions, ideas and special offers go to command.com
CAUTION:
DO NOT use with wallpaper. May not
adhere well to vinyl surfaces. DO NOT
use for antiques, heirlooms, or other
valuable or irreplaceable items.
DO NOT hang items over beds.
NOTE:
Apply to surfaces above 15°F
(-10°C). Adhesive could lose
adhesion above 125°F (50°C).
Caddy can be reused with
Command™ Large Water
Resistant Strips.
The following statements only apply to products
distributed in the USA.
Limited Warranty:
This 3M product will be free from defects in
material and manufacture. If this product is
defective, your exclusive remedy shall be, at 3M’s
option, replacement of the product or refund of
the purchase price.
Limitation of Liability:
3M will not be liable for any loss or damage
arising from this product, whether direct, indirect,
special, incidental or consequential.