Command™ Instructions

17021P
command.com
To Apply
1
CLEAN surface with
isopropyl rubbing alcohol,
wipe gently, let dry. Do not
use household cleaners.
SEPARATE strips.
5
RED
SIDE
REMOVE RED liner.
PRESS adhesive to hook.
UP
4
3
2
BLACK
SIDE
REMOVE BLACK liner.
PRESS to surface
for 10 seconds.
7
6
8
1 HOUR
30
SECONDS
IMPORTANT: For maximum
holding strength
slide hook off.
DOWN
And press base FIRMLY
for 30 seconds.
Slide hook ON.
Wait 1 hour before use.
To Remove
1
UP
3
2
STRAIGHT
DOWN
Slide hook up to remove
from mounting base.
NEVER pull strip
towards you.
Hold base gently to
prevent base from
snapping fingers.
DO NOT press base
against wall.
S
L
O
W
L
Y
4
12"
30 cm
STRETCH STRAIGHT
DOWN ALONG WALL
AT LEAST 12 INCHES
(30 cm) until base
and strip release.
IMPORTANT: Failure to follow instructions carefully may cause damage!
SAVE INSTRUCTIONS for damage-free removal or visit command.com
For questions, ideas and special offers go to command.com
CAUTION:
DO NOT use with wallpaper. May
not adhere well to vinyl surfaces.
DO NOT use for antiques,
heirlooms, or other valuable or
irreplaceable items. DO NOT
hang items over beds.
NOTE:
Apply to surfaces above 50°F
(10°C). Adhesive could lose
adhesion above 105°F (40°C).
Not intended for picture hanging.
Instead use Command
Hanging Strips, Sawtooth or
Wire-Backed Hangers.
The following statements only apply to products distributed in the USA.
Limited Warranty:
This 3M product will be free from defects in material and manufacture.
If this product is defective, your exclusive remedy shall be, at 3M’s option,
replacement of the product or refund of the purchase price.
Limitation of Liability:
3M will not be liable for any loss or damage arising from this product,
whether direct, indirect, special, incidental or consequential.