THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0907 TFLB530E 10.0MHZ SURFACE MOUNT 3.3V LVCMOS TCXO with TRI-STATE OUTPUT ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature UNITS Supply Voltage MINIMUM -40 (Vcc) NOMINAL - MAXIMUM 85 UNITS °C -0.5 - 7 Vdc -0.5 - 7 Vdc MINIMUM 6.4 -3.0 0 NOMINAL - MAXIMUM 50.00 3.0 70 UNITS MHz ppm °C Vdc Enable / Disable Voltage OPERATING SPECIFICATIONS NOTE DESCRIPTION TABLE 2.0 PARAMETER Frequency Range Frequency Tolerance Operating Temperature Range TFLB530E TABLE 1.0 (Fo) Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - 8 20 mA Jitter (BW=10Hz to 20MHz) - - 5 ps rms Jitter (BW=12kHz to 20MHz) SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset - -70 -100 -125 -135 -145 1 - ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz INPUT CHARACTERISTICS NOTE 1 TABLE 3.0 Enable Voltage (High) (Vih) 70% Vcc - - Vdc Disable Voltage (Low) (Vil) - - 30% Vcc Vdc 2 The Connor-Winfield TFLB530E is a Surface Mount Temperature Compensated Crystal Oscillator (TCXO). Operating at 3.3Vdc, the TFLB530E will maintain ±3.0ppm frequency tolerance over 15 years. The TFLB530E is offered in a surface mount package for automated assembly. FEATURES 3.3V OPERATION LVCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) (Voh) (Vol) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% TABLE 4.0 MINIMUM 2.2 - NOMINAL - MAXIMUM 15 0.4 UNITS pF Vdc Vdc -4 45 - 50 3 4 55 5 mA mA % ns (Ioh) (Ioh) PACKAGE CHARACTERISTICS Package NOTE OVERALL FREQUENCY TOLERANCE: ±3.0ppm OVER 15 YEARS. TEMPERATURE RANGE: 0 to 70°C LOW JITTER <1pS RMS TRI-STATE ENABLE/DISABLE SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. PROCESS RECOMMENDATIONS TABLE 6.0 Solder Reflow Wash RoHS 5/6. See solder profile on page 2. Ultrasonic cleaning is not recommended. RoHS 5/6 COMPLIANT ORDERING INFORMATION TFLB530E - 010.0M Note: 1) Inclusive of calibration, frequency vs. temperature stability, supply voltage change, load change, shock and vibration, 15 years aging. 2) Oscillator output is enabled with no connection on pad 6 TCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Tx113 PAGE 1 OF 2 REV: 02 DATE: 02/23/09 aCopyright 2009 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 0907 TFLB530E 10.0MHZ Package Outline Suggested Pad Layout 6 .100 (2.54mm) Dimensional Tolerance: ±.005 (.127mm) Output Waveform Pad Connections Pad 1 6 7 8 14 90% 50% Connection N/C Enable / Disable Ground Output Vcc 10% Test Circuit Solder Profile Temperature 225°C 3.3Vdc Ramp-Up Rate 3°C/second max. from 150°C to 225°C. 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C 100°C 6 N/C 25°C E/D 0 Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET #: Tx113 PAGE 2 OF 2 REV: 02 DATE: 02/23/09 aCopyright 2009 Connor-Winfield all rights reserved.