LPCV Series • Linear proportional controller • Ratings from 15A to 110A @ 240 VAC • 0-5 V DC, 0-10 V DC, or 4-20mA input • For use with resistive loads only PRODUCT SELECTION Description 15 A 25 A 40 A 75 A 110 A 0-5 VDC Control 5LPCV2415 5LPCV2425 5LPCV2440 5LPCV2475 5LPCV24110 0-10 VDC Control 10LPCV2415 10LPCV2425 10LPCV2440 10LPCV2475 10LPCV24110 4-20 mA Control 20LPCV2415 20LPCV2425 20LPCV2440 20LPCV2475 20LPCV24110 OUTPUT SPECIFICATIONS (voltage) (1) Description 240 VAC Operating Voltage (60Hz) [Vrms] 20-300 Transient Overvoltage [Vpk] 600 Maximum Off-State Leakage Current @ Rated Voltage [mArms] 10 Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] 200 OUTPUT SPECIFICATIONS (current) (1) Description 15 A 25 A 40 A 75 A Maximum Load Current [Arms] 15 25 40 75 110 A 110 Minimum Load Current [Arms] 0.10 0.10 0.10 0.15 0.20 Maximum Surge Current (16.6ms) [Apk] 150 250 625 1000 1500 Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.6 1.6 1.6 1.6 Thermal Resistance Junction to Case (Rjc) [°C/W] 1.48 1.02 0.63 0.31 0.28 Maximum I² t for Fusing (8.3 msec) [A² sec] 94 260 1620 4150 9340 Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 0.5 0.5 INPUT SPECIFICATIONS (1) Description 5LPCV 10LPCV Control Voltage Range 0-5 VDC 0-10 VDC 4-20 mA -0.5/10 VDC -1.0/20 VDC -0.5/25 mA Control Range Limits (Min/Msx) Turn-On Threshold 20LPCV 0.25 VDC 0.5 VDC 4.5 mA Nominal Input Impedance 12.7K Ohm 25 K Ohm 460 Ohm Sync Voltage (terminal 6 and 7) 16-24 VAC 16-24 VAC 16-24 VAC POWER SUPPLY SPECIFICATION (4) Description PS120 PS240 Input Voltage 50/60Hz 120 VAC 240 VAC Output Voltage 50/60Hz (Sync Voltage) 20 VAC/100mA 20 VAC/100mA Ambient Operating Temperature Range -30 to 80°C -30 to 80°C Ambient Storage Temperature Range -40 to 125°C -40 to 125°C Terminals Screw Torque Requirement Weight (typical) 6-32 Screws, .25" Fastons 6-32 Screws -10 in lbs. 8.6 oz. (245g) GENERAL SPECIFICATIONS Description Dielectric Strength, signal to load 2500 Vrms Dielectric Strength, signal to Base 2500 Vrms Ambient Operating Temperature Range -30 to 80°C Ambient Storage Temperature Range -40 to 125°C Weight (typical) 6.0 oz. (175g) Encapsulation Terminals Screw Torque Requirement Themally Conductive Epoxy 8-32 Screws, .25" Fastons 8-32 and 10-32 Screws - 20in. lbs. GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Linear taper potentiometer 1-10K Ohm, ½ watt. 3) 50Hz models available. 4) 20 VAC must be in phase with load THERMAL DERATE INFORMATION TYPICAL APPLICATIONS • Infrared and quartz heaters • Thermal forming equipment • Resistive heating elements • Conveyor speed control • Rectified DC motors • Printing applications • Industrial temperature controllers WIRING DIAGRAM PERCENT VS INPUT VOLTAGE AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 Rev. 110411 ANNEX - ENVIROMENTAL INFORMATION