SS1J-G IATF 0113686 SGS TH07/1033 SURFACE MOUNT SUPER FAST RECTIFIER PRV : 600 Volts Io : 1.0 Ampere DO-215AC FEATURES : 2.6 ± 0.2 4.3 ± 0.2 Glass passivated jungtion chip High current capability High surge current capability High reliability Low reverse current Low forward voltage drop Super fast recovery time Pb / RoHS Free 2.4 ± 0.2 * * * * * * * * TH09/2479 TH97/2478 www.eicsemi.com 1.4 ± 0.2 6.2 ± 0.2 Dimensions in millimeters MECHANICAL DATA : * Case : DO-215AC Molded plastic * Epoxy : UL94V-0 rate flame retardant * Polarity : Color band denotes cathode end * Mounting position : Any * Weight : 0.060 gram (Approximately) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. RATING SYMBOL VALUE UNIT Maximum Recurrent Peak Reverse Voltage VRRM 600 V Maximum RMS Voltage VRMS 420 V Maximum DC Blocking Voltage VDC 600 V Maximum Average Forward Current Ta = 55 °C IF(AV) 1.0 A IFSM 30 A VF 1.7 V IR 5.0 µA Maximum Reverse Recovery Time ( Note 1 ) Trr 35 ns Typical Junction Capacitance ( Note 2 ) CJ 50 pf Junction Temperature Range TJ - 65 to + 150 °C Storage Temperature Range TSTG - 65 to + 150 °C Maximum Peak Forward Surge Current 8.3 ms. Single half sine wave Superimposed on rated load (JEDEC Method) Maximum Peak Forward Voltage at IF = 1.0 A Maximum DC Reverse Current at Rated DC Blocking Voltage Notes : ( 1 ) Reverse Recovery Test Conditions : IF = 0.5 A, IR = 1.0 A, Irr = 0.25 A. ( 2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 VDC Page 1 of 2 Rev. 00 : March 1, 2011 TH09/2479 TH97/2478 IATF 0113686 SGS TH07/1033 www.eicsemi.com RATING AND CHARACTERISTIC CURVES ( SS1J-G ) FIG.1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 50 Ω 10 Ω Trr + 0.5 A D.U.T. + 0 PULSE GENERATOR ( NOTE 2 ) 50 Vdc (approx) 1Ω - 0.25 A OSCILLOSCOPE ( NOTE 1 ) - 1.0 A SET TIME BASE FOR 15 ns/cm NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF. 1 cm 2. Rise time = 10 ns max., Source Impedance = 50 ohms. 3. All Resistors = Non-inductive Types. FIG.2 - DERATING CURVE FOR OUTPUT FIG.3 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 1.0 30 PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD OUTPUT CURRENT, AMPERES RECTIFIED CURRENT 0.8 0.6 0.4 0.2 Ta = 50 °C 24 18 12 6 8.3 ms SINGLE HALF SINE WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 0 0 25 50 75 100 125 150 0 175 1 2 AMBIENT TEMPERATURE, ( °C) 6 10 20 40 60 100 NUMBER OF CYCLES AT 60Hz FIG.4 - TYPICAL FORWARD CHARACTERISTICS FIG.5 - TYPICAL REVERSE CHARACTERISTICS 100 10 INSTANTANEOUS REVERSE CURRENT, MICROAMPERES FORWARD CURRENT, AMPERES 4 10 1.0 TJ = 100 °C 1.0 0.1 TJ = 25 °C 0.01 0.1 Pulse Width = 300μs 2% Duty Cycle 0 20 40 60 80 100 120 140 PERCENT OF RATED REVERSE VOLTAGE, (%) TJ = 25 °C 0.01 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 FORWARD VOLTAGE, VOLTS Page 2 of 2 Rev. 00 : March 1, 2011