I/SPE/IBxxx2/A/02/03/2010 page 1 /1 GB IBxxxx2 DETECTEUR DE POSITION ANGULAIRE SANS MERCURE TIP OVER SWITCH- NO MERCURY CONTACTS "Opened" (1) 10° DIMENSIONS : mm (inches) Differential Angle 15° Max 10° Ø 5,940 (0,234) 22,1 (0,870) "Closed" (1) Remarks: These switches operate when tilted from the horizontal position. The switch movement required to cause contact change (ex OFF to ON) is called the differential angle. It is very important when the designing a tilt switch to allow for the differential angle and understand that when in the horizontal position the switch contact may be open or closed. 2,9 (0,115) 10,2 (0,400) 2x0,50 (0,020) Ø 4,7 (0,185) HORIZONTAL CARACTERISTIQUES PHYSIQUES et ELECTRIQUES / ELECTRICAL & PHYSICAL DATA CONTACT FORM (TYPE) SWITCHING VOLTAGE SWITCHING CURRENT SWITCHING CAPACITY OPERATING ANGLE / HORIZONTAL (Opened/Closed) DIFFERENTIAL ANGLE CONTACT RESISTANCE OPERATING TEMPERATURE STORAGE TEMPERATURE CASE MATERIAL CABLE / TERMINATION (1) Dependent of mounting 60 250 3 ± 10° 15 30 -35° / +100°C -40° / +100°C Tin plated Pin Max. Vac Max. mA Max. VA Max. Deg° Max. Deg° Max. Ω Deg° C Deg° C Remarks: When cutting or bending switch leads it is important that the glass seal is not damaged. The cutting or bending point should be no closer than 3mm to the glass seal and the lead should be supported between the cutting or bending point an glass to metal seal. Proud to serve you celduc r e l a i www.celduc.com s Rue Ampère B.P. 4 42290 SORBIERS - FRANCE E-Mail : [email protected] Fax +33 (0) 4 77 53 85 51 Service Commercial France Tél. : +33 (0) 4 77 53 90 20 Sales Dept.For Europe Tel. : +33 (0) 4 77 53 90 21 Sales Dept. Asia : Tél. +33 (0) 4 77 53 90 19