Page | 1 EMPB85xx n tio ra USB cable n Co u fig e bl ca EMEVB8500 Solar cell Your EMEVB8500 Evaluation Kit contains: EMEVB8500 evaluation board EMPB85xx Configuration tool USB Cable - Configuration cable Solar cell Full documentation for EMEVB8500 and EMPB85xx is available on EM’s website http://www.emmicroelectronic.com/emdownloads/EM8500/doc/empb8500_user_guide.pdf http://www.emmicroelectronic.com/emdownloads/EM8500/doc/emevb8500_user_guide.pdf To start evaluating EM8500 and developing your application this quick start document guides you through the set-up of your evaluation hardware kit and software. [email protected] http://www.emdeveloper.com http://www.emmicroelectronic.com EMEVB8500 QUICK START GUIDE Page | 2 Software download Download the EMPB85xx Configuration software tool from EM website http://www.emmicroelectronic.com/emdownloads/EM8500/SetupEMPB85xx.exe Install the downloaded EMPB85xx Configuration tool software For additional questions please refer to the EMPB85xx User Guide Configure the EMPB85xx Place the jumpers as shown below JP9 Place jumper on JP9 JP8 Place jumper on JP8 JP2 – JP3 Place jumper on JP2 [1-2] and JP3 [1-2] 3 2 1 For additional questions please refer to the EMPB85xx User Guide [email protected] http://www.emdeveloper.com http://www.emmicroelectronic.com EMEVB8500 QUICK START GUIDE Page | 3 Configure the EMEVB85xx Place the jumper as shown below I2C - J6A – J6B Place jumpers on J6A and J6B [email protected] http://www.emdeveloper.com http://www.emmicroelectronic.com EMEVB8500 QUICK START GUIDE Page | 4 Connect the configuration cable from the EMPB85xx to the EMEVB85xx Connect Connect Connect Connect Connect Connect cable cable cable cable cable cable from from from from from from JP4.3 JP5.3 JP5.1 JP4.4 JP5.2 JP4.5 to to to to to to PRG.1 PRG.2 PRG.3 PRG.4 PRG.5 PRG.8 (VSS) (VSS-CS) (VSUP) (SCL) (STS) (SDA) JP5.1 JP5.2 JP5.3 JP4.3 JP4.4 VSS S DA JP4.5 SCL +3 .3V -V SU +3 P .3V -S TS VSS - CS Complete step [email protected] http://www.emdeveloper.com http://www.emmicroelectronic.com PRG.1 PRG.2 PRG.4 PRG.8 PRG.3 first then PRG.5 ! EMEVB8500 QUICK START GUIDE Page | 5 USB cable connection Connect USB cable from the PC to the EMPB85xx. Verify EMPB85xx USB detection (FT4222) in Device Manager / Universal Serial Bus controllers FT4222H Mode 3 Device. Check the communication Click on the shortcut “EM Microelectronic” “EMPB85xx Command Line and console”. Type the following command empb85xx –test The message below indicates that communication to the programmer and to the EM8500 device is established. [email protected] http://www.emdeveloper.com http://www.emmicroelectronic.com