Model # BR9556 Available as: BR9556, SMA Connectorized Housing (H2) RF/Microwave Amplifier Features • Low Noise Figure: < 1 dB Typical • Unconditionally Stable • Low +5 volt supply powered through the SMA Output Port. • Environmental Screening Available Maximum (No Damage) Ratings Technical Specifications Storage Temperature -55ºC to + 100 ºC Operating Temperature -62ºC to + 125 ºC CHARACTERISTIC TYPICAL Ta=25ºC MIN/MAX Ta = -55ºC to +85ºC Frequency (MHz) 1200 - 1700 1200 - 1700 27 25.0 Min. Power @ 1 dB Comp. (dBm) +15 +14 Min. Reverse Isolation (dB) -38 -36 Max. In 1.8:1 2.0:1 Max. Out 1.8:1 2.0:1 Max. Noise Figure (dB) <1.0 1.75 Max. Second Order Harmonic Intercept Point: +46 dBm (Typ.) Power Vdc +5* +5* Second Order Two Tone Intercept Point: +46 dBm (Typ.) mA 60 63 Max. Third Order Two Tone Intercept Point: +26 dBm (Typ.) Gain (dB) VSWR Case Temperature + 125 ºC DC Voltage + 8 Volts Continuous RF Input Power + 13 dBm Short Term RF Input Power 50 Milliwatts (1 Minute Max.) Maximum Peak Power 0.5 Watt (3 μsec Max.) Typical Intermodulation Performance at 25ºC Notes: • Care should always be taken to effectively ground the case of each unit. • +5 volt operation powered through the SMA Output Port. • The unit’s +5 volt Bias will operate off +5 volts dc supplied through the RF Output Port. • The model BR9556 housing will retain the standard dimensions (Length, Width, and Height) found aboard the existing H2 Housing, however, there will not be a separate DC Connector for the +5 volt supply. Typical Performance Data Rev Date: 5/2/2014 © API Technologies Corp. Proprietary Information Page # 1 | www.apitech.com | micro.apitech.com | +1.888.553.7531 | [email protected]