Model # BXHF1230 High Frequency Microwave Amplifier Frequency Range: 2-18 GHz Features • High Frequency and Broad Bandwidth: 2-18 GHz • Laser Welded Housing for Ultimate Environmental Protection • Customized Housing with DC SMA Connector • Internal +28 volt Regulator Model BXHF1230 is a high frequency amplifier covering 2-18 GHz. This design utilizes a laser sealed housing for superior environmental protection. All specification ratings are based on measurements in a 50 Ω (ohm) system with a DC supply voltage tolerance of +/- 2%. Typical Intermodulation Performance at 25 ºC Technical Specifications Parameter Unit Typical Min/Max Frequency Range GHz 2 to 18 2 to 18 Gain dB 11.5 10 Gain Variation over Temperature dB 1.0 1.4 Noise Figure* dB 3.5 4.5 dBm 12 10 Reverse Isolation dB -20 --- Input VSWR --- 1.5:1 2.0:1 Output VSWR** --- 1.5:1 2.0:1 Supply Voltage volts +28 Supply Current mA 75 Output Power @ 1 dB Compression Second Order Harmonic Intercept Point: +30 dBm (Typ.) Second Order Two Tone Intercept Point: +26 dBm (Typ.) Third Order Two Tone Intercept Point: +20 dBm (Typ.) Note: Intercept Values Measured at 10 GHz. • • * Noise Figure at 2000 MHz is 5.5 dB. ** Output VSWR is 2.5:1 below 5 GHz. Absolute Maximum (No Damage) Ratings Operating Temperature -55ºC to +100 ºC +28 Storage Temperature -62ºC to +125ºC 100 Case Temperature +125 ºC DC Voltage +30 Volts Continuous RF Input Power +13 dBm Short Term RF Input Power 200 Milliwatts (1 Minute Max.) Maximum Peak Power 0.5 Watt (3 µsec Max.) Mechanical & Electrical Parameter Specification Specification Temperatures (Min/Max) -20°C to +70°C Housing Size 0.870” L x 1.060” W x 0.300” H Housing Drawing Customized HF1 Package RF Connectors SMA Female Replaceable Connectors (DC, RF-In and RF-Out) Rev Date: 4/25/2016 © API Technologies Corp. Proprietary Information Page # 1 | www.apitech.com | micro.apitech.com | +1.888.553.7531 | [email protected]