Flow Application Questionnaire Thermatel Model TA2 (Please fill out in detail.) bULLETIN: 54-350.7 REFERENcE INFoRMATIoN Customer/Company: Date: Contact/Title: Phone: Fax: FOR OFFICE USE: Submitted by: INSTRUMENT Model Number: Electronics Probe/Flow Body: Remote Cable: Compression Fitting/RPA: Quantity: PRocESS DATA Application: Gas composition (vol%): Condensed Moisture in Gas? No Yes Dust Buildup? Maximum None Light Normal Heavy Type of Dust: Minimum Units Flow Rate Temperature Pressure STP coNDITIoNS Specify Standard Temperature and Pressure conditions (If not specified Magnetrol uses 70° F and 1 Atmosphere) Temperature: Pressure: 1 Atmosphere 1 Bar PIPE DIMENSIoNS DUcT INTERNAL DIMENSIoNS Pipe Diameter: inch Schedule or Pipe ID: Diameter units or Metric Pipe: Rectangular dimensions mm OD units units mm wall thickness FAcToRy coNFIgURATIoN (Check one) SCFM* Nm3/min lbs/min* SCFH* Nm3/h* lbs/h* SCFD Nm /d lbs/d MSCFD NI/min kg/min* MMSCFD* NI/h* kg/h* NI/d kg/d 3 4 mA value (0%) 20 mA value (100%) Flow Temperature (TA2-A4) * Indicates which units are available for FOUNDATION™ fieldbus option F PRobE LENgTh cALcULATIoNS The probe can be ordered in 0.1 inch or 1 cm increments. This is most important when used with a flange or threaded connection to ensure that the sensor is located on the centerline of the pipe. The active portion of the sensor is located 1" (2.5 cm) from the end of the probe. Refer to illustration at right. D/2 D 1"(2.5 cm) REMARKS 705 Enterprise Street • Aurora, Illinois 60504-8149 • 630-969-4000 • Fax 630-969-9489 [email protected] • www.magnetrol.com Copyright © 2015 Magnetrol International, Incorporated. All rights reserved. Printed in the USA. BULLETIN: 54-350.7 EffEcTIvE: January 2015 SUPERSEDES: December 2010