Download this Data sheet

96 MHz SAW Filter
5 MHz bandwidth
Part Number SF0096BA02438S
DESCRIPTION
•
•
•
96 MHz SAW bandpass filter with 5 MHz bandwidth.
13.3 x 6.5 mm SMP.
RoHS compliant.
TYPICAL PERFORMANCE
Horizontal:
Vertical from Top:
Frequency :
Relative Magnitude :
Relative magnitude :
Phase Linearity :
Group Delay Deviation :
S11
4
10
0.8
10
100
MHz/div
dB/div
dB/div
deg/div
ns/div
S22
Spectrum Microwave
400 Nickerson Road, Marlborough, MA 01752, USA • Phone 1-508-251-6400 • Fax 1-508-251-6401
www.SpectrumMicrowave.com
DSSF0096BA02438S Rev B 22-Feb-2010
ECN 36650 Page 1 of 3
96 MHz SAW Filter
5 MHz bandwidth
Part Number SF0096BA02438S
SPECIFICATION
Parameter 1
Center Frequency (Fc) 3
Minimum Insertion Loss
1 dB Bandwidth
15 dB Bandwidth
Passband Variation (Fc +/- 1.92 MHz)
Phase Linearity (Fc +/- 1.92 MHz)
Group Delay Variation (Fc +/- 1.92 MHz) 2
Absolute Delay
Change in Absolute Delay (from unit to unit)
Absolute Delay Variation (from -40˚C to 55˚C)
Input Return Loss (Fc+/-1.92 MHz)
Output Return Loss (Fc+/-1.92 MHz)
Rejection (40 to 87 MHz)
Rejection (105 to 150 MHz)
Source and Load Impedance
Ambient Temperature
Notes:
Min
95.9
5.00
-10
10
10
43
43
-
Typ
96.0
13.5
5.38
7.48
0.5
2.4
35
1.23
0
5
13
13
48
48
50
25
Max
96.1
15
8.00
0.8
5.0
80
3
10
15
-
Units
MHz
dB
MHz
MHz
dB p-p
deg p-p
ns p-p
us
ns
ns
dB
dB
dB
dB
Ω
°C
1. All dB levels are referenced to the insertion loss
2. A smoothing aperture of 0.125 MHz may be applied to this measurement.
3. Average of lower and upper 3 dB frequencies; applies at 23°C only.
MAXIMUM RATINGS
Parameter
Storage Temperature Range
Operating Temperature Range
Input Power Level
Min
Max
-40
-40
-
85
55
13
Units
˚C
˚C
dBm
MATCHING CIRCUIT
Input
50 Ω
Single ended
Typical component values:
(Minimum inductor Q = 40)
Output
50 Ω
Single ended
Ls1 = 91 nH
Lp1 = 39 nH
Rp1 = 4.7 KΩ
Ls2 = 150 nH
Lp2 = 47 nH
Rp2 = 1.8 KΩ
Notes
• Suggest the use of 2% tolerance matching components.
• Tuning values shown are for reference only. Optimum values may change depending upon board layout.
Spectrum Microwave
400 Nickerson Road, Marlborough, MA 01752, USA • Phone 1-508-251-6400 • Fax 1-508-251-6401
www.SpectrumMicrowave.com
DSSF0096BA02438S Rev B 22-Feb-2010
ECN 36650 Page 2 of 3
96 MHz SAW Filter
5 MHz bandwidth
Part Number SF0096BA02438S
PACKAGE OUTLINE
SUGGESTED FOOTPRINT
Units: mm
Tolerances are ±0.15 mm except
for the overall length and width,
which are nominal values.
Pad Configuration:
Input:
1
Output:
6
Ground:
All other pads
Package Material:
Body: Al2O3 ceramic
Lid: Kovar, Ni plated
Terminations: Au plating 1 µm min,
over a 1.3-8.9 µm Ni plating
ISO 9001
Registered
All specifications are believed to be accurate and reliable. However, Spectrum Microwave reserves the right to make changes without notice.
© 2010 All rights reserved.
Spectrum Microwave
400 Nickerson Road, Marlborough, MA 01752, USA • Phone 1-508-251-6400 • Fax 1-508-251-6401
www.SpectrumMicrowave.com
DSSF0096BA02438S Rev B 22-Feb-2010
ECN 36650 Page 3 of 3