RM 1

SANKEN ELECTRIC CO., LTD.
RM1
1 Scope
The present specifications shall apply to an RM1.
2 Outline
Type
Silicon Diode (Mesa Type)
Structure
Resin Molded
Applications
Commercial Frequency Rectification
Flammability : UL94V-0(Equivalent)
3 Absolute maximum ratings
No.
Item
Symbol
Unit
Rating
Conditions
1
Transient Peak Reverse Voltage
VRSM
V
400
2
Peak Reverse Voltage
VRM
V
400
3
Average Forward Current
IF(AV)
A
1.0
Refer to derating curve
in Section 6
4
Peak Surge Forward Current
IFSM
A
50
10ms.
Half sine wave, one shot
5
I2t Limiting Value
I2 t
A2s
12.5
6
Junction Temperature
Tj
°C
-40 to +150
7
Storage Temperature
Tstg
°C
-40 to +150
1ms≦t≦10ms
4 Electrical characteristics (Ta=25°C, unless otherwise specified)
No.
Item
Symbol
Unit
Rating
Conditions
1
Forward Voltage Drop
VF
V
0.95 max.
IF=1.0A
2
Reverse Leakage Current
IR
µA
5 max.
VR=VRM
3
Reverse Leakage Current Under
High Temperature
H・IR
µA
50 max.
VR=VRM, Tj=100°C
4
Thermal Resistance
Rth(j-l)
°C/W
15 max.
Between Junction and Lead
040826
1/3
61426-01
SANKEN ELECTRIC CO., LTD.
RM1
5.VF test and test circuit
6. Derating
Derating to the ambient temperature
Power loss generated by voltage is not taken into consideration.
100
Percentage Against (%)
80
60
40
20
0
-40
-20
0
20
40
60
80
100
120
140
Ambient Temperature (°C)
040826
2/3
61426-01
SANKEN ELECTRIC CO., LTD.
7.
RM1
Dimensions, inner structure and marking
7.1 Dimensions refer
※1
※3
φ0.78 ±0.05
φ4.0 ±0.2
62.5± 0.7
7.2± 0.2
※2
Dimensions in mm
*1 The allowance position of body against the center of whole lead wire is 0.5mm (max.)
*2 The centric allowance of lead wire against center of physical body is 0.3mm (max.)
*3 The burr may exist up to 2mm from the body of lead.
7.2 Appearance
The body shall be clean and shall not bear any stain, rust or flaw.
The color of the case will be black.
7.3 Marking
①Polarity marking (Cathode band)
②Type marking : 2 set marking Ex.) RM1
RM1
③Lot No. marking : 2 set marking Ex.) 48…
48…
4: Year (Last digit of calendar year)
8 : Month (From 1 to 9 for Jan. to sep.,)
O for Oct., N for Nov., and D for Dec.
Ten days (・ : First ten days
・・ : Second ten days
・・・ : Third ten days)
The color of marking must be white.
The marking on the case of a part, which is printed in two positions,
should be legible in either of the two at least.
040826
3/3
61426-01