NJT1946A

Technical
Information
Rev.1
NJT1946A
X-Band Radar Front End
NJT1946A is designed for the front end of marine radar system.
It features a small size and a light weight operable at any frequency between 9.345GHz and
9.475GHz.
This front end module consists of HEMT low noise amplifier, Image rejection mixer, Local VCO with
buffer amplifier.
A HEMT monitoring circuit is included in the design to monitor HEMT drain current.
The stability of the local VCO frequency by the input RF power is increased effectively by the buffer
amplifier which is located between image rejection mixer and local VCO.
- ELECTRICAL - < at 25 ºC >
Min
4.8
-
10.5
-
9.560
-
4.0
-10.0
-
-
Operating voltage
Operating current
Tuning Voltage (Note1)
Local frequency
VT= 4V
VT=24V
Noise figure
Conversion gain
1dB Gain compression point(RF Port)
RF single pulse burnout (Note2)
RF repetitive pulse burnout (Note3)
Typical
5.0
70
12.0
-
-
2.5
6.0
-8.0
-
-
Max
5.2
90
13.5
9.380
-
3.5
8.0
-
600
400
Unit
V
mA
V
GHz
GHz
dB
dB
dBm
mW
mW
Note1: fLO=9.470GHz
Note2: fRF=9.410GHz, Pd=10nsec
Note3: fRF=9.410GHz, Pd=1µsec, Duty=0.001
- BLOCK DIAGRAM -
Balanced
Mixer
WG-MIC
Transition
LNA
0deg
0deg
TUNE
Buffer
Amplifier
IF OUT
RF IN
Divider
90deg
Monitor
Circuit
0deg
Lo.VCO
Balanced
Mixer
MONITOR
OUT
For further information on the use of the front end, please contact New JRC.
New JRC reserves the right to change the specification of goods without notice.
1-1,Fukuoka 2-chome, Fujimino-city
Saitama prefecture. 356-8510 Japan
11.08
Phone:049-278-1297
Fax :049-278-1419
Technical
Information
Rev.1
1-1,Fukuoka 2-chome, Fujimino-city
Saitama prefecture. 356-8510 Japan
Phone:049-278-1297
Fax :049-278-1419