M1568BS

Technical
Information
Rev.6
M1568BS
X-Band Magnetron
M1568BS is designed for the magnetron of x-band radar system. The frequency
range is fixed <9380~9440MHz> and the peak output power is 25kW.
── MAXIMUM RATINGS ──
Min
Max
Unit
Peak anode current ······················
6.0
10
A
Peak anode power input ··················
-
75
kW
Duty cycle ······························
-
0.001
-
Pulse duration ··························
0.05
1.2
μs
Rate of rise of voltage pulse ···········
-
90
kV/μs
Anode
temperature ······················
-
110
℃
V.S.W.R at the output coupler ···········
-
1.5:1
-
── ELECTRICAL ──
Min
Typical
Max
Unit
Heater voltage (Note 1) ··············
6.0
6.3
6.6
V
Preheat time ·························
120
-
-
S
Peak anode voltage (Note 2) ··········
7.2
8.0
8.5
kV
Peak output power (Note 2) ···········
22.5
25
-
kW
Frequency (Note 2) ···················
9380
9410
9440
MHz
Note 1: Measured with heater voltage of 6.3V and no anode input power, the heater current
1imits are 0.43A minimum, 0.6A maximum. For average pulse input powers greater than
25 watts the heater voltage must be reduced within 3 seconds after the application of
h. t. according to the following schedule:
Heater Voltage : Ef  6.3 1 -
Pi
[V]
100
Pi :Input Power (Average)[W]
Note 2: Measured at peak anode current 8.0A
1-1,Fukuoka 2-chome, Fujimino-city
Saitama-prefecture 356-8510 Japan
Phone:049-278-1298
Fax :049-278-1419
Technical
Information
Rev.6
Note 3: Any overshoot of the anode current is not acceptable. The impedance of
this magnetron is the same as current magnetron excluding the transient
impedance. This means that the additional reactance should be required
for adjustment the anode current wave form, if this magnetron will be
installed into the similar modulator circuit as before.
1-1,Fukuoka 2-chome, Fujimino-city
Saitama-prefecture 356-8510 Japan
Phone:049-278-1298
Fax :049-278-1419