tm5150pm.pdf

Available as:
RF AMPLIFIER
MODEL TM5150PM
TM5150PM, 4 Pin TO-8 (T4)
TN5150PM, 4 Pin Surface Mount (SM3)
FP5150PM, 4 Pin Flatpack (FP4)
BX5150PM, Connectorized Housing (H1)
Features
Typical Intermodulation Performance at 25 ºC
!
!
!
!
Second Order Harmonic Intercept Point ....... +48 dBm (Typ.)
Second Order Two Tone Intercept Poin ......... +43 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +32 dBm (Typ.)
Low Noise Figure: 2.5 dB Typical
Output Power: +18 dBm Typical
Operating Temp. -55 ºC to +85 ºC
Environmental Screening Available
Absolute Maximum (No Damage) Ratings
Specifications
CHARACTERISTIC
Frequency
Gain (dB)
Power @ 1 dB
Comp. (dBm)
Reverse
Isolation (dB)
VSWR
In
Out
Noise Figure (dB)
Power
Vdc
mA
TYPICAL
Ta= 25 ºC
10 - 300 MHz
20.0 +5
MIN/MAX
Ta = -55 ºC to +85 ºC
10 - 300 MHz
19.0 Min.
+18
+17 Min.
-23
1.75:1
1.5:1
2.5
-22 Max.
2.5:1 Max.
2.0:1 Max.
3.5 Max.
+15
47
+15
53 Max.
Ambient Operating Temperature ................ -55ºC to +100 ºC
Storage Temperature ................................. -62ºC to +125 ºC
Case Temperature .................................................. +125 ºC
DC Voltage .......................................................... +18 Volts
Continuous RF Input Power .................................. +13 dBm
Short Term RF Input Power ............. 50 mW (1 Minute Max.)
Maximum Peak Power .................... 0.5 Watt (3 µsec Max.)
Guaranteed @ 25 ºC (160 MHz) Phase Noise Performance (dBc/Hz)*
Frequency
100 Hz
1 kHz
10 kHz
100 kHz
1 MHz
Note: Care should always be taken to effectively ground the case of each unit.
Guarantee (min.)
Typical
- 162
- 170
- 172
- 173
- 173
- 158
- 168
- 170
- 170
- 170
*Note: Phase Noise Performance typically tested at midband.
Bandedge performance may vary.
Typical Performance Data
Gain (dB)
21
Phase Noise (dBc/Hz)
Reverse Isolation (dB)
0
-1 30
-10
20
-20
-30
19
-40
Start 10 MHz
+20
1 dB Comp. (dBm)
Stop 30 0 MHz
-140
-15 0
Start 10 MHz
4
Stop 30 0 MHz -16 0
Noise Figure (dB)
+19
-18 0
3
+18
- 19 0
1 00
+17
+16
Start 10 MHz
3.0
2
Input VSWR
Sto p 3 00 MHz
Sta rt 10 MHz
Output VSWR
Legend
Stop 300 MHz
+25 ºC
10 k
10 0k
1M
Stop 30 0 MHz
Noise Test Conditions:
Carrier Frequency: 160 mHz
*Phase
Power Output: +18 dBm
1.5
Start 1 0 MH z
1k
Typical
2.0
2.0
1.0
-17 0
1.0 Sta rt 10
Temperature: 25 ºC
Agilent ES5500 System
MHz
Stop 30 0 MHz
+85 ºC - - - - - - -55 ºC
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532
Rev.
4/22/09
www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001