SMD 14 Pin 10 Tap TTL Compatible Active Delay Lines ELECTRONICS INC. EPA245-XX & EPA245-XX-RC Add “-RC” after part number for RoHS Compliant PCA Part Number EPA245-50(-RC) EPA245-60(-RC) EPA245-75(-RC) EPA245-100(-RC) EPA245-125(-RC) EPA245-150(-RC) EPA245-175(-RC) EPA245-200(-RC) EPA245-225(-RC) EPA245-250(-RC) EPA245-300(-RC) EPA245-350(-RC) EPA245-400(-RC) EPA245-420(-RC) Test Conditions Min. V CC = min. V IL = max. I OH = max 2.7 V CC = min. V IH = min. I OL = max V CC = min. II = II K V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V IIL Low-Level Input Current V CC = max. VIN = 0.5V IOS Short Circuit Output Current V CC = max. V OUT = 0. -40 (One output at a time) ICCH High-Level Supply Current V CC = max. VIN = OPEN ICCL Low-Level Supply Current V CC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS NH Fanout High-Level Output V CC = max. V OH = 2.7V NL Fanout Low-Level Output V CC = max. V OL = 0.5V High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current Max. Unit 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA Recommended Operating Conditions Min. Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 4.75 2.0 Max. Unit 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 *These two values are inter-dependent. 14 VCC 13 3 12 4 11 5 10 OUTPUT 9 8 6 INPUT 1 7 GROUND Gull-Wing Package PCA EPA245-XX(-RC) Date Code .055 (1.40) Suggested Solder Pad Layout .280 Max. (7.11) .410 (10.41) .030 (.762) .100 (2.54) .780 Max. (19.81) .010 Typ. (.254) .250 Max. (6.35) .020 (.508) 440 450 470 500 550 600 650 700 750 800 850 900 950 1000 Schematic 150 mA 150 mA 4 nS 5 nS 20 TTL Load 10 TTL Load .400 Max. (10.16) VCC VIH VIL IIK IOH IOL PW* d* TA Total Delay (†±5% or ± 2nS) Tap Delays PCA (†±5% or ± 2nS) Part Number 5 50 EPA245-440(-RC) 44 6 60 EPA245-450(-RC) 45 7.5 75 EPA245-470(-RC) 47 10 100 EPA245-500(-RC) 50 12.5 125 EPA245-550(-RC) 55 15 150 EPA245-600(-RC) 60 17.5 175 EPA245-650(-RC) 65 20 200 EPA245-700(-RC) 70 22.5 225 EPA245-750(-RC) 75 25 250 EPA245-800(-RC) 80 30 300 EPA245-850(-RC) 85 35 350 EPA245-900(-RC) 90 40 400 EPA245-950(-RC) 95 42 420 EPA245-1000(-RC) 100 †Whichever is greater. Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter VOH VOL VIK IIH Total Delay (†±5% or ± 2nS) Tap Delays (†±5% or ± 2nS) .100 (2.54) Notes : 1. Assembly Process (Solder Composition) .050 (1.27) (Leadframe) (Assembly Solder) .300 (7.62) EPA245-XX SnPb EPA245-XX-RC Sn SnPb SnPb (RoHS exemption 7a) 2. Peak Solder Rating Input Pulse Test Conditions @ 25° C EIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS VCC Supply Voltage Unit 3.2 110 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts 225°C 260°C (per IPC/JEDEC-J-STD-020C) 3. Moisture Sensitive Levels (MSL) (per IPC/JEDEC-J-STD-020C) 4. Weight 5. Packaging Information (*Add “TR” to end of part number when placing order) (Tube) 3 4 (168 hours, ≤30°C/60%RH) (72 hours, ≤30°C/60%RH) TBD grams TBD grams 27 pieces/tube 27 pieces/tube (Tape & Reel) TBD pieces/13” reel (*EPA245-XX-TR) TBD pieces/13” reel (*EPA245-XX-RCTR) Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CSA245 & -RC Rev. A1 12/5/05 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com