Document 132 Current Sense Transformers These low cost Coilcraft current sensing transformers are designed for use up to 1 MHz. They incorporate the current and sense windings in one small, encapsulated package requiring minimum board space. Coilcraft current sensing transformers are designed to meet UL/CSA/IEC 60950 Reinforced Insulation specification and provide 3 mm creepage/clearance between primary and secondary windings. Winding to winding isolation (hipot) is 3750 Vrms, tested for one minute. Applications include feedback control, overload sensing, detecting load drop or shutdown, and proportional output. Coilcraft Designer’s Kit P403 contains the three standard current sensing transformers, sensor-only versions of each, plus two 50/60Hz current sensors. To order, contact Coilcraft or visit http://order.coilcraft.com. DCR max FrequencyVolt-time Sensed Terminating product2current (Ohms)range Iin resistance RT3 pri sec (kHz) (Vµsec) max (A) (Ohms) Inductance1 Turns (N) Part number pri : sec min (mH) CS4050V-01L CS4100V-01L CS4200V-01L 1 : 50 1 : 100 1 : 200 5 20 80 0.001 0.001 0.001 0.7 1.4 4.0 1. Inductance is for the secondary, measured at 15.75 kHz, 1 Vrms. 2. Volt-time product is for the secondary, based on 2000 Gauss. 3. Terminating resistance (RT) value is based on 1 Volt output with 35 Amps flowing through the primary. Varying terminating resistance increases or decreases output Voltage/Ampere according to the following equation: RT = Vout × Nsec / Iin 3 – 1000 2 – 1000 1 – 1000 149 298 596 35 35 35 1.4 2.9 5.7 4. Ambient temperature range –40°C to +85°C. 5. Electrical specifications at 25°C. CS4xx0V-AL Typical Circuit 2 I in Pri (1 turn) 3 0.75 max 19,05 1 Sec (N turns) Vout RT XXXX Y Internal code 4 Recommended PC Board Layout (viewed from top) 2 CL 1 0.088 2,23 0.069 1,76 0.20 ±0.005 5,08 ±0,125 CL 3 4 0.30 ±0.005 7,62 ±0,125 0.03 0,76 0.77 max 19,56 3 0.40 ±0.01 10,16 ±0,25 0.105/0.150 2,67/3,81 0.57 max 14,48 4 0.041 1,041 0.052 1,321 1 2 0.060 × 0.460 1,52 × 11,68 Weight: 8.8 – 9.3 g Terminations: Tin-silver over copper Packaging: 29 per tube Document 132 Revised 06/25/15