Document 594 Flyback Transformer For Texas Instruments LM5001 Switch Mode Regulator • Developed for the Texas Instruments LM5001 High Voltage Switch Mode regulator for isolated and non-isolated flyback topologies. • Output of the auxiliary winding is 7.5 V used to power the IC • 1500 Vrms, one minute isolation from the primary and auxiliary winding to the secondary Core material Ferrite Terminations RoHS tin-silver over tin over nickel over phos bronze. Weight 6.28 g Ambient temperature –40°C to +85°C Storage temperature Component: –40°C to +85°C. Tape and reel packaging: –40°C to +80°C Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 175 per 13″ reel Plastic tape: 32 mm wide, 0.5 mm thick, 32 mm pocket spacing, 12.98 mm pocket depth PCB washing Only pure water or alcohol recommended Leakage InductanceInductance 3 Ipk3 DCR max (Ohms)4inductance Turns ratio6 Part at 0 A2 at Ipk number1 ±10% (µH) min (µH) pri bias sec max (µH)5pri : sec pri : aux(A) Output FA2636-AL_ 160 144 0.225 0.340 0.078 1.60 8 : 28 : 3 1.0 5.0 V, 1.0 A 1. When ordering, please specify packaging code: FA2636-ALD Packaging:D =13″ machine-ready reel. EIA-481 embossed plastic tape (175 parts per full reel). B=Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter D instead. 2. Inductance is for the primary, measured at 250 kHz, 0.2 Vrms, 0 Adc. 3.Ipk is peak primary current drawn at minimum input voltage. 4. DCR for the secondary is per winding. 5. Leakage inductance measured between pins 3 and 2 with all other pins shorted. 6. Turns ratio is with the secondary windings connected in parallel. 7. Operating temperature range –40°C to +85°C. 8. Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. Dot above pin1 3 Pri 0.500 max 12,70 2 4 0.004 /0,10 0.039 1,00 6 7 6 5 0.028 0,70 5 0.061 1,55 0.590 14,99 0.050 1,27 Secondary windings to be connected in parallel on the PC board. Recommended Land Pattern 0.530 max 13,46 10 Sec Aux 0.699 max 17,75 0.512 13,00 8 9 1 0.098 2,50 0.098 2,50 1 Dimensions are in inches mm US +1-847-639-6400 [email protected] UK +44-1236-730595 [email protected] Taiwan +886-2-2264 3646 [email protected] China +86-21-6218 8074 [email protected] Singapore + 65-6484 8412 [email protected] Document 594 Revised 09/03/08 © Coilcraft Inc. 2013 This product may not be used in medical or high risk applications without prior Coilcraft approval. Specification subject to change without notice. Please check web site for latest information.