UNISONIC TECHNOLOGIES CO., LTD P2583 LINEAR INTEGRATED CIRCUIT 380KHz, 3A STEP-DOWN SWITCHING REGULATOR DESCRIPTION The UTC P2583 is a fixed 380kHz frequency, current mode, PWM controller with an internal power MOSFET. It achieves 3A continuous output current over a wide input supply range with excellent load and line regulation. Equipped with an external compensation pin, this device offers user flexibility in determining loop dynamic. The UTC P2583 integrates controls, monitoring and protection functions into a single 8-pin package to provide a low cost and perfect power solution. The device provides wide 3.6V to 28V operating input range, also highly efficient with peak operating efficiency at 90%. An Under- Voltage-Lock-Output (UVLO) circuit monitors the Vin supply voltage to prevent wrong logic controls. An internal 1.222V reference provides low output voltage down to 1.22V for further applications. The controller’s over-current protection monitors the output current by using the voltage drop across a current sensing resistor. Additional under voltage protections monitor the voltage on FB pin for short-circuit protections. The UTC P2583 provides fast transient respond and requires very few external devices for operation. FEATURES * 3A Output Current * Vin=3.6V,Vout=2.5V,Iload_max up to 3A * 380kHz frequency of operation * 3.6V to 28V Input Voltage Range * 25μA Shutdown Supply Current * Output Adjustable from 1.22V to 21V * Frequency FoldBack at Short Circuit * Thermal Shutdown * Under Voltage Lock Output * Current Mode with Low ESR Output Ceramic Capacitors * Up to 90% Efficiency ORDERING INFORMATION Ordering Number Lead Free Halogen Free P2583L-S08-R P2583G-S08-R P2583L-S08-T P2583G-S08-T P2583G-S08-R (1)Packing Type Package Packing SOP-8 SOP-8 Tape Reel Tube (1) R: Tape Reel, T: Tube (2)Package Type (2) S08: SOP-8 (3)Halogen Free (3) G: Halogen Free, L: Lead Free PIN CONFIGURATION www.unisonic.com.tw Copyright © 2012 Unisonic Technologies Co., Ltd 1 of 6 QW-R103-052.C P2583 LINEAR INTEGRATED CIRCUIT NC 1 8 SS IN 2 7 EN SW 3 6 COMP GND 4 5 FB PIN DESCRIPTION PIN NO. 1 2 3 4 5 PIN NAME NC IN SW GND FB 6 COMP 7 EN 8 SS DESCRIPTION NC Power Supply pin. Power Switch Output pin. Ground pin. The output voltage feedback pin. It is also the inverting input of the error amplifier. Compensation pin. It is also the output of the internal error amplifier. (1). A RC network at this pin compensates the control loop. (2). The voltage at this pin controls the peak current of the internal switch. Regulator On/Off Control pin. Leave EN unconnected if unused. A low input at EN turns on the converter, and a high input turns it off. Soft Start UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 6 QW-R103-052.C P2583 LINEAR INTEGRATED CIRCUIT BLOCK DIAGRAM IN 2 EN 7 NC 1 UVLO Reference OTP Current Sense + + + Slope COMP COMP 6 1.22V FB 5 + EA + - PMOS PWM LEB - S Rsense Driver Q R SS 8 UVLO UVLO 3 SW Slope COMP Slope COMP 4 GND 50K-380KHz UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 6 QW-R103-052.C P2583 LINEAR INTEGRATED CIRCUIT ABSOLUTE MAXIMUM RATING (Note 2) PARAMETER SYMBOL RATINGS UNIT Supply Voltage VIN 28 V Switch Voltage VSW -1~ VIN+1 V Feedback Voltage VFB -0.3~6 V Enable/UVLO Voltage VEN -0.3~6 V Comp Voltage VCOMP -0.3~6 V Sync Voltage VSYNC -0.3~6 V Junction Temperature TJ 150 °C Storage Temperature TSTG -65~+150 °C Note:1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. Exceeding these ratings may damage the device. RECOMMENDED OPERATING CONDITIONS (Note 3) PARAMETER SYMBOL RATINGS Input Voltage VIN 3.6~28 Ambient Operating Temperature TA -40 ~ +125 Note: 3. The device is not guaranteed to function outside its operating rating. UNIT V °C PACKAGE THERMAL CHARACTERISTICS (Note 4) PARAMETER SYMBOL RATINGS Junction to Ambient θJA 105 Junction to Case θJC 50 Note: 4. Measured on approximately 1” square of 1 oz. Copper surrounding device leads. UNIT °C/W °C/W ELECTRICAL CHARACTERISTICS (Unless otherwise specified VIN=12V, TA=25°C) PARAMETER Feedback Voltage Switch On Resistance Upper Switch Leakage Current Limit Current Limit Gain. Output Current to Comp Pin Voltage Error Amplifier Transconductance Oscillator Frequency Short Circuit Frequency Maximum Duty Cycle Minimum Duty Cycle Enable Threshold Enable Pull Up Current Supply Current (quiescent) Shutdown Current Thermal Shutdown SYMBOL TEST CONDITIONS VFB 4.75V ≤ VIN ≤ 25V, VCOMP < 2V RSW IO(OFF) VEN =0V, VSW =0V ILIMIT TYP 1.222 0.11 0 MAX 1.246 15 3.3 5.5 ΔIC =±10μA F F DMAX DMIN VEN IEN ICC ISD T VFB=0V VFB =1.0V VFB =1.5V ICC > 100μA VEN =0V VEN ≥2.6V; VFB =1.4V VEN =0V UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN 1.198 500 342 25 800 380 50 90 A/V 1100 418 75 0 1.2 1.5 2.2 20 160 UNIT V Ω µA A 3.5 35 µA/V KHZ KHZ % % V µA mA µA °C 4 of 6 QW-R103-052.C P2583 LINEAR INTEGRATED CIRCUIT TYPICAL APPLICATION CIRCUIT UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 6 QW-R103-052.C P2583 LINEAR INTEGRATED CIRCUIT TYPICAL CHARACTERISTICS Efficiency(%) UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 6 of 6 QW-R103-052.C