LG-JT02 OPIC Photointerrupter with Connector ■ Outline Dimensions ■ Features 1. Uses 3-pin connector terminal 2. High sensing accuracy (Slit width : 0.5mm) 3. Wide gap between light emitter and detector (5mm) (Unit : mm) .2 0 2± . φ4 ■ Applications 7 Protrusion of connector from holder : Max.1.0 10.5 (Ta=25˚C) Rating Unit V −0.5 to +8 −0.5 to +28 V 50 mA −20 to +75 ˚C ˚C −40 to +85 LG-JT02 7.5 Symbol VCC VOUT IOL Topr Tstg 3.5 Slit width0.5±0.1 15 5 5 3.0 ■ Absolute Maximum Ratings Parameter Suppl voltagey *1 Output voltage *2 Low level output current *3 Operating temperature *3 Storage temperature 1 2 3 3.5 1. Copiers, Printers 2. Facsimiles *1 Collector-emitter voltage of output transistor. *2 Collector current of output transistor. *3 The connector should be plugged in/out at normal temperature. C0.5 Connector made by J.S.T. MFG. CO., LTD. B3P-SHF-1AA 34.0 9.2±1 5.5±1 3.5 11 +0 0.1 − φ4 11±0.1 12±0.1 ❈ Unspecified tolerances shall be as follows Dimensions (d) Tolerance d<4.0 ±0.2 4.0<=d<16.0 ±0.3 16.0<=d ±0.5 1 Voltage regulator Amp. integrated onto a single chip. 2 1 3 2 3 VCC GND VO * "OPIC" (Optical IC) is a trademark of the SHARP Corporation. An OPIC consists of a light-detecting element and signal-processing circuit TEL:020-84859506 84851526 FAX:020-84851726 http://www.evercolors.com E-mail:[email protected] LG-JT02 ■ Electro-optical Characteristics Parameter Operating supply voltage Low level supply current Low level output voltage High level supply current High level output voltage *4 Response frequency (Unless otherwise specified, VCC=5V, Ta=25˚C) Unit TYP. MAX. MIN. Symbol Conditions V − 4.5 5.5 VCC mA − − 30 ICCL Light beam uninterrupted V − − 0.35 VOL Light beam uninterrupted, IOL=16mA mA − − 30 Light beam interrupted ICCH V − − Light beam interrupted, RL=47kΩ VCC×0.9 VOH No DC output is allowed, RL=47kΩ Hz − 3 000 − f *4 Refer to Fig.1 Fig.1 Response Frequency 0.5 0.5 2.0 Disk Response frequency is measured with the disk shown below being rotated. (Unit : mm) Fig.3 Low Level Output Voltage vs. Low Level Output Current 60 1.0 50 0.5 Low level output voltage VOL (V) Low level output current IOL (mA) Fig.2 Low Level Output Current vs. Ambient Temperature 40 30 20 16.6 10 0 −20 VCC=5V Ta=25˚C 0.2 0.1 0.05 0.02 0.01 0 25 50 75 Ambient temperature Ta (˚C) TEL:020-84859506 84851526 FAX:020-84851726 100 1 2 5 10 20 50 100 Low level output current IOL (mA) http://www.evercolors.com E-mail:[email protected] LG-JT02 Fig.4 Low Level Output Voltage vs. Ambient Temperature Fig.5 Supply Current vs. Supply Voltage 0.6 30 VCC=5V Supply current ICC (mA) Low level output voltage VOL (V) 0.5 0.4 IOL=30mA 0.3 0.2 16mA 0.1 20 Ta=−20˚C ICCL 10 ICCH +25˚C +75˚C Ta=−20˚C, +25˚C, +75˚C 5mA 0 0 −25 0 25 50 75 4.5 100 5.0 5.5 Supply voltage VCC (V) Ambient temperature Ta (˚C) Fig.6 Detecting Position Characteristics (1) VCC=5V Ta=25˚C RL=47kΩ Fig.7 Detecting Position Characteristics (2) VCC=5V Ta=25˚C RL=47kΩ Output OFF Output OFF Shield d Shield h Output ON 0 1 2 3 4 5 6 Shield distance d (mm) Detecting position d=3.5±0.3mm TEL:020-84859506 84851526 FAX:020-84851726 7 Output ON 0 1 2 3 4 5 6 Shield distance h (mm) +2.0 Detecting position h=3.0 −1.5mm 7 http://www.evercolors.com E-mail:[email protected] LG-JT02 ■ Recommended Connectors on the Inserted Side ◆ JAPAN SOLDERLESS TERMINAL MFG. CO., LTD. made Housing Model No. H3P-SHF-AA AWG size Special terminal Model. No. AWG 28 to 22 AWG 30 to 28 Material Model No. Brass SHF-001T-0.8SS Copper phosphide SHF-001T-0.8BS Brass SHF-002T-0.8SS Copper phosphide SHF-002T-0.8BS TEL:020-84859506 84851526 FAX:020-84851726 (Natural color • bulk) S3P-SHF-1 AWG size AWG 27 to 22 AWG 30 to 28 Material Model No. Brass SHF-001T-0.8P Copper phosphide − Brass SHF-002T-0.8P Copper phosphide − http://www.evercolors.com E-mail:[email protected]