First version: A1, 2007-03-09 EMC specification of product FlexProgrammer 9701 1. Introduction 2. The product 3. Relevant standards 4. Test plan 5. Definition of error criterions 1. Introduction 1.1 Aim: To set up minimum requirements to meet the protection requirements in the EMC directive 2004/108/EC. 2. The product 2.1 The product: Configuration tool for other products. 2.2 Type: Product type no. FlexProgrammer 9701 Sidste side: 4 File name: 5506096 B1.doc Dato for sidste rev.: 2009-10-26 Rev.: B1 QA: THH Side: 1 Dok. Nr.: 5506-096 2.3 Environmental use: Industry. 2.4 Description of the product: Construction: The product contain a circuit board. The module contain analogue circuits and low power CPU circuits. The module has the following ports: - USB - Flex bus (two terminals). Adjustments: The product has been adjusted from factory. 3. Relevant standards 3.1 Emission: EN 61326. 3.2 Immunity: En 61326. The following tests are estimated to be relevant: - CISPR 16 and 16-1: Emission. - EN 61000-4-3: HF field, 80 - 1000 MHz, 80% AM, 3 V/m. Criterion A. USB - EN 61000-4-3: HF field, 80 - 1000 MHz, 80% AM, 10 V/m. Criterion C. USB - EN 61000-4-3: HF field, 80 - 1000 MHz, 80% AM, 10 V/m. Criterion A. Standalone - EN 61000-4-2: ESD discharge 8/4 kV. Criterion A. All ports are considered signal ports. 4. Test plan 4.1 Connected to the USB port, the connection during measurement will be observed during the test. Finally it’s verified the data in FlexProgrammer isn’t changed. 4.2 Regarding emission no test has been made. The very low power consumption also indicates, that the device does not radiate any considerable noise. Sidste side: 4 File name: 5506096 B1.doc Dato for sidste rev.: 2009-10-26 Rev.: B1 QA: THH Side: 2 Dok. Nr.: 5506-096 5. Error criterions 5.1 Criterion A: No malfunctions during test and no data change after the test has been performed. 5.2 Criterion B: No requirements during the test run. After the test run, the module shall operate normally. 5.3 Criterion C: No requirements during the test run. After the test run, with action from the operator, reset etc. the module shall operate normally. Sidste side: 4 File name: 5506096 B1.doc Dato for sidste rev.: 2009-10-26 Rev.: B1 QA: THH Side: 3 Dok. Nr.: 5506-096 DECLARATION OF CONFORMITY We, Baumer A/S Jacob Knudsens Vej 14 8230 Aabyhoj Denmark Tel: +45 89 31 76 11 declare under our sole responsibility that the product Product Name: FlexProgrammer 9701 Product Description: Configuration tool Product Type: FlexProgrammer 9701 to which this declaration relates is in conformity with the following European Directives: 2004/108/EC And related European Standards. EN 61 326 Sidste side: Issue 1. 2006-11-03 4 File name: 5506096 B1.doc Dato for sidste rev.: 2009-10-26 Rev.: B1 QA: THH Side: 4 Dok. Nr.: 5506-096