The following document contains information on Cypress products. CM44-10120-4ET3 Errata This errata sheet is for MB90460/465 Series Hardware Manual Rev.4 (CM44-10120-4E) F2MC-16LX 16-BIT MICROCONTROLLER MB90460/465 Series HARDWARE MANUAL Date 2011/ 8/2 Page 29 Item 3.2 2011. 8.2 Description The following description of "Figure 3.2-1 Sample Relationship between the F2MC-16LX System and the Memory Map" was corrected as indicated by shading below. (Error) (Correct) [mcu_doc1011] 1/4 Date 2009/ 4/2 Page 449 Item 16.6 Description The following description of "Figure 16.6-3 Pulse-width Measurement Operation (Single Measurement Mode, H-width Measurement Mode)" was corrected as indicated by shading below. (Error) (Correct) [mcu_doc0872] 2/4 Date 2009/ 4/2 Page 449 Item 16.6 Description The following description of "Figure 16.6-4 Pulse-width Measurement Operation (Continuous Measurement Mode, H-width Measurement Mode)" was corrected as indicated by shading below. (Error) (Correct) [mcu_doc0872] 3/4 Date 2009/ 4/2 Page 549 Item Description 20.4.1 Function of "bit11, bit10" in "Figure 20.4-2 A/D Control Status Register 1 (ADCS1)" was corrected as indicate by shading below. (Error) STS1 0 1 0 0 STS0 0 1 1 1 A/D activation select bit Activation by software Activation by external trigger or software Activation by timer or software Activation by external trigger, timer, or software (Correct) STS1 0 1 STS0 0 1 A/D activation select bit Activation by software Activation by 16-bit free-run timer zero detection or software Activation by 16-bit reload timer 1 output(Rising edge)or software Activation by 16-bit free-run timer zero detection, 16-bit reload timer 1 output(Rising edge) or software 0 1 0 1 [mcu_doc0493] 2008/ 11/4 694 APPEN ■Table B.9-20 XCH Ri, ea Instruction (First Byte = 7EH) is changed. DIX B ・Error Item "A" Line of +A "W2+d16,A" ・Correct Item "A0" Line of +A "@RW2+d16" 4/4